Metal and hydrogen ion acidity and extreme nitrate concentrations typical of
Department of Energy (DOE) legacy waste sites pose formidable challenges to
successful implementation of in situ bio-immobilization. Intermediate-scale (~ 2.5 m),
flow through models of an in situ bio-barrier were constructed to investigate U and Tc
removal from groundwater...
This research examines the downstream fining phenomenon as it operates in coastal gravel-bed rivers of Oregon. Downstream fining is a change in bed composition toward smaller sediment sizes in the downstream direction. Changes in stream flow discharge and channel slope affect the rate of bed-load transport, thereby altering the downstream...
Forest roads produce fine sediment with traffic during wet weather. If the forest road is connected to a stream it can be a source of turbidity and fine sediment that may be detrimental to aquatic organisms especially salmonids.
The goal of this work was to investigate turbid runoff during wet-weather...
Despite recent efforts to improve site safety, construction still accounts for a disproportionate injury and illness rate. According to the 2007 injury and illness data released by the National Safety Council, the construction industry has a fatality and disabling injury rate that is approximately three times higher than the all-industry...
Many conventionally reinforced concrete deck girder (RCDG) bridges were built in the US during the 1950s, throughout the expansion of the Interstate System. Designs followed the AASHO standard of the time, which permitted higher shear stress in concrete and reduced detailing requirements than permitted by current specifications. Many of these...
This thesis explores the factors limiting the alkene substrate range of the vinyl chloride (VC)-utilizing bacteria, and describes a method for measuring VC transformation in situ. Vinyl fluoride (VF) was evaluated as a surrogate for monitoring aerobic VC-transformation utilizing three isolates, Mycobacterium EE13a, Mycobacterium JS60 and Nocardioides JS614. JS614 grew...
Wave breaking in the surf zone is an important forcing
mechanism on the generation of nearshore currents and in the driving
of sediment transport. At the same time, wave breaking can have
significant spatial and temporal variability that needs to be
accounted for in the description of nearshore processes. Remote...
This research focused on anaerobic transformation of trichloroethene (TCE), a
groundwater contaminant. The mixed anaerobic Evanite culture (EV) was studied to determine community behavior and composition responses to different electron donors and chloroethene electron acceptors. The potential toxicity from high concentrations of TCE and its daughter product cis-1,2-dichloroethene (cDCE) was...
Many conventionally reinforced concrete deck girder bridges (RCDG) and their intermediate supporting bent caps were designed during the Eisenhower interstate era of the 1950’s with the AASHO design equations at the time, which subsequently place higher demand on the concrete. The referenced components may exhibit diagonal cracking due to the...
Hydrodynamic models are used as a diagnostic tool to understand the temporal variability of shallow-water processes that are difficult to completely resolve with traditional field measurements. For all simulations, modeled quantities are qualitatively or quantitatively compared with available measurements to gain confidence in conclusions derived from the modeled results. In...
Recently, the concept of performance based design has become popular for many types of structures, including port facilities under seismic loading. For the case of pile-supported wharves, the level of performance is generally estimated using the displacement capacity of the structure. Therefore, understanding soil-pile interaction is one of the most...
A new set of data from a large-scale sand bar migration experiment is presented. During this experiment, two sandbars were generated. One of the bar was generated by the action of undertow, and sediment moved offshore. The other bar was generated by the shoreward movement of sediment coming from the...
The rural two-lane highway in the southeastern United States is frequently associated with a disproportionate number of serious and fatal crashes. The major research objectives are to investigate the relations between probabilities of fatal crash type occurrence and potential contributing factors from road geometric design characteristics and roadside, environmental features....
Non-destructive testing methods and applications have become of increasing interest due to the worldwide aging and deteriorating infrastructure network. In the field of Civil Engineering, bridges and bridge components as well as non-structural elements such as roadway pavements for example, are affected. In particular, the Acoustic Emission (AE) technique offers...
Due to age, original design that is deficient by modern standards, inadequate maintenance, environmental conditions, and increasing loads, large numbers of bridges in United States and elsewhere are classified as deficient and in need of rehabilitation or replacement. According to a national bridge inventory established by the Federal Highway Administration,...
Probability-based reliability methods have placed an increased emphasis on realistic simulation of structural behavior in bridge engineering. Uncertainty is present in every aspect of structural analysis. Aleatory uncertainties in the loading and load-carrying capacities, and epistemic uncertainties in mathematical idealization of bridge systems are the major contributors to uncertain structural...
Different specimen preparation methods such as moist tamping, dry funnel deposition, slurry deposition, dry air pluviation have been reported in the literature to investigate the undrained behavior of silty sands. Similarly, different means have been used to densify the soils prepared with such methods. However, the influence of the densification...
Fluid-structure interaction (FSI) is an interesting and challenging interdisciplinary area comprised of fields such as engineering- fluids/structures/solids, computational science, and mathematics. FSI has several practical engineering applications such as the design of coastal infrastructure (such as bridges, levees) subjected to harsh environments from natural forces such as tsunamis, storm surges,...
This dissertation presents the results of a research effort conducted to better understand the stress-strain, volume change, shear band formation, and strength characteristics of normally consolidated anisotropic clay under fully three-dimensional stress states. A series of consolidated drained true triaxial tests with a constant mean effective stress and constant Lode...
Pile supported bridges are typically constructed near or in a natural or man-made
slope and are subjected to lateral loading. The current design method for laterally loaded
piles involves the use of Winkler's spring concept with the standard nonlinear p-y curves.
The available p-y curves were developed based on results...
Engineers, in practice, are often faced with the challenge of evaluating a fire-damaged structure and developing a rehabilitation and retrofit plan. In order to decide on a rehabilitation and retrofit plan, information on thermal degradation of building materials and connections are vital. A critical knowledge gap exists in terms of...
In this dissertation the interactions between hydrodynamics, sediment suspension and transport, and morphological evolution in the surf zone was investigated with a large-scale laboratory experiment data, CROss-Shore Sediment Transport Experiment (CROSSTEX). The data set included comprehensive measurements of water surface elevation, fluid velocity, sediment concentration, and morphology for irregular waves...
Halogenated organic compounds have had widespread and massive applications in industry, agriculture, and private households, for example, as degreasing solvents, flame retardants and in polymer production. They are released to the environment through both anthropogenic and natural sources. The most common chlorinated solvents present as contaminants include tetrachloroethene (PCE, perchloroethene)...
During the past several decades, earthquakes have caused extensive damage to
buildings, including wood-frame, single-family dwellings, in the United States. In
order to mitigate future losses, existing buildings in earthquake prone areas should be
evaluated for their seismic safety. This is also an important issue for buildings in
Oregon due...
Posting advisory speed signs at sharp horizontal curve sites is a practice well established in the United States. The purpose of these signs is to provide the driving public with a safe speed to negotiate such curves; however, the link between these signs and safety has not yet been clearly...
Reflection of an obliquely incident solitary wave at a vertical wall is studied experimentally in the laboratory wave tank. Precision measurements of water-surface variations are achieved with the aid of laser-induced fluorescent (LIF) technique and detailed temporal and spatial features of the
Mach reflection are captured. During the development stage...
It has been suggested that projects in the construction industry are subject to risks more than other industries. However, there is often little parity in allocation of risks in the construction industry. Usually, project participants allocate risks by aversion where owners tend to shift risks to the primary contractor, who...
The trenchless technology known as pipe ramming for construction of culverts and buried pipes under roadways or other infrastructure has gained significant popularity due to its cost-effectiveness and ability to alleviate surface disruptions associated with open-cut trenching. Although the experience with pipe ramming is increasing, there has been remarkably little...
To better understand the extreme local amplification of tsunami, the experimental investigation on counter-propagating solitary wave collisions over a horizontal bottom was conducted using the optical measurement techniques: Particle Image Velocimetry (PIV), and Laser Induced Fluoresce (LIF). Head-on collisions and oblique collisions of equal-amplitude as well as unequal-amplitude waves were...
In the field of civil infrastructure, bridge desks are typically constructed using high performance concrete (HPC). Concrete bridge decks demand qualities such as low permeability, high abrasion resistance, superior durability, and long design life. Over decades of field and laboratory experience, many HPC bridge decks have been found to be...
The construction industry employs about 7% of the total US workforce, and yet it accounts for 15.7% of all occupational fatalities. Specifically in 2011, there were 721 deaths in construction, second only to transportation with 733. The cause of a large number of these construction deaths can be attributed to...
There are about 80 million single-family dwellings (SFD) in the United States, predominantly of wood-frame construction. Of these, 68% are owner occupied. A home is typically the largest single investment of a family, and is often not covered by earthquake insurance, even where it is available. Of all SFD in...
In this study, a coupled potential flow-viscous flow model is used for numerical wave tank simulation. The solver satisfies all the requirements for such a simulation environment. The coupling scheme is based on a non-overlapping heterogeneous domain decomposition method. In this method, the flow domain consists of two subdomains. In...
The production of cement and concrete results in the production of large amounts of CO₂ emissions which can have significant negative environmental impacts. Using supplementary cementing materials (SCMs) as a cement replacement is an effective solution to reduce these negative environmental impacts, as most SCMs are waste by-products from other...
This dissertation examines tsunami and hurricane wave loads on bridge superstructures. Tsunamis have caused significant damage to coastal communities in recent years. For example, the 2011 Great East Japan Earthquake and resulting Tohoku Tsunami destroyed infrastructure along the east coast of Japan including bridge superstructures. Recent hurricanes have also caused...
Deep foundations are necessary for the construction of many structures, such as bridges and buildings, located in areas unsuitable for shallow foundations. Owing to the inherent variability of soil and the complex changes that occur in the soil adjacent to deep foundations as they are installed, the ability to accurately...
Discrete columns, such as stone and soil-cement columns, are often used to improve the liquefaction resistance of loose sandy ground. In particular, stone columns are considered to increase resistance potential by densification, drainage, and reinforcement mechanisms. For silty soil, the shear stress reduction resulting from the reinforcing effect of stiffer...
Landslides are a pervasive hazard that can result in substantial damage to properties and loss of life throughout the world. To understand the nature and scope of the hazard, landslide hazard mapping has been an area of intense research by identifying areas most susceptible to landslides in order to mitigate...
Traffic signal countdown timers (TSCT) are innovative, practical and cost effective technologies with the potential to improve efficiency and safety at signalized intersections. The purpose of these devices is to assist motorists in decision making at signalized intersections with real time signal change information. While successful implementation of these devices...
To facilitate the evaluation and design of structures subjected to fluid loading, a study of fluid-structure interaction (FSI) using the particle finite element method (PFEM) is presented to approximate the responses and sensitivities of structures which interact with fluid. A wide range of structural types are permissible by making no...
Fluid-structure interaction (FSI) is a very interesting and challenging multi-disciplinary field involving interaction of a movable or deformable structure with an internal or surrounding fluid flow. FSI has several practical engineering applications such as the determination of the hydrodynamic forces on a structure or the dynamics of motion of bodies...
This dissertation has focused on the charateristics of bubbles generated by breaking waves and the feedback of wave-current interaction on the forcing mechanism of low frequency wave especially basin seiching wave. For the first study, Optical image capture observations of breaking waves in a laboratory surf zone are presented. The...
A Right-hook (RH) crash is a common type of bicycle-motor vehicle crash that occurs between a right-turning vehicle and through-moving bicycle at an intersection. At signalized intersections, RH crashes can occur at the onset of the green or during the latter portion of the green phase. In spite of the...
This dissertation focuses on two core aspects of remote sensing: (a) interpretation of the remotely sensed data to identify and characterize sea surface features of interest, and (b) the quantitative analysis of previously characterized features to produce robust estimates of geophysical variables. Specifically, these aspects are addressed in the context...
There is renewed interest in North America for the use of calcium aluminate cement (CAC) in infrastructure repair. The interest is driven by the specialty properties that make CAC the ideal candidate for particular applications. These include rapid strength gain, even at temperatures approaching 0°C, the ability to customize fresh...
The understanding and prediction how coastal wetland vegetation attenuates wave action has received renewed attention with global climate change impacts and increasing populations on coastlines. Conventional attenuation models utilize empirical drag coefficients, but these coefficients exhibit a wide range of values, and there is some uncertainty in the relative importance...
It is expected that information taught in the context of school will ultimately transfer to workplace settings. To support this transition, educators and researchers advocate for organizing foundational ideas, or concepts, in specific domains of knowing. In the domain of transportation engineering, knowing of concepts, which include "big ideas" such...
This research explores several novel approaches to improve visualization and segmentation
of point clouds acquired with 3D laser scanning. 3D laser scanning is used
in a wide variety of applications including surveying and mapping, transportation asset
management, facilities management, building information modeling, crime scene investigations,
cultural heritage and geologic instigations....
Degradation of watersheds is a major concern in areas where adverse climate effects and unsustainable use of the natural resources have caused extensive stresses to watershed systems (e.g., increased floods, increased droughts, worsened in-stream water quality) through the years. While considerable efforts are being made to generate technical solutions that...
Former industrial or commercial sites that have been left unused are typically referred to as brownfield sites, or simply, brownfields. Many communities have such properties that are abandoned, idle or underused. Despite public efforts to facilitate brownfields revitalization projects, the rate of remediation remains unexpectedly slow. Efforts to resolve this...