Index Catalog // ScholarsArchive@OSU

Wave forces on a horizontal circular cylinder near a plane boundary

Creator:: Wright, James Christopher
Resource Type:: Masters Thesis
Full Text:: Wave forces on a horizontal circular cylindar near a plane

The application of centrifugal modeling to determine ice forces on isolated circular structures

Creator:: Clough, Herbert F.
Abstract:: A test system was developed and used to investigate ice/structure interaction with centrifugal modeling. The test system was designed to perform two main functions: (1) create a uniform ice sheet, and (2) drive a model structure through the ice sheet at a constant speed. Both of these functions were required...
Resource Type:: Masters Thesis
Full Text:: forces on isolated circular structures AN ABSTRACT OF THE THESIS OF Herbert F. Clough for the degree

Behavior of cellular bulkheads in deep sands

Creator:: Maitland, James Keith
Abstract:: Large-scale experiments on circular model cell bulkheads were conducted to define the distribution of hoop stresses, deflections of the cells, distortion of the cell fill, ultimate overturning resistance, and the critical mode of failure. The embedment depth of the model cells was varied to investigate the effect of embedment on...
Resource Type:: Dissertation
Full Text:: experiments on circular model cell bulkheads were conducted to define the distribution of hoop stresses

Evaluation of Driver Behavior during Right Turn Maneuvers at Signalized Intersections: Mitigation of Driver-Pedestrian Conflicts with a Right Turn Flashing Yellow Arrow

Creator:: Jashami, Hisham
Abstract:: Accommodating motor vehicles that are turning (left or right) at signalized intersections requires a careful understanding of the safety and efficiency of design and operational variables. Turning vehicles are the primary collision risk for non-motorized road users at signalized intersections. When turning movements need to be controlled, proper driver response...
Resource Type:: Dissertation
Full Text:: drivers were presented with a steady red arrow display as compared to a steady circular red display

Large scale model testing of the FMC submerged wave attenuation device

Creator:: Huber, David S.
Abstract:: This report describes the hydrodynamic testing and evaluation of a one-tenth scale model of the FMC Wave Attenuation Device. The purpose of the test was to quantify the wave attenuation characteristics and structural loading induced by a test program of monochromatic incident waves on the submerged structure. The device was...
Resource Type:: Masters Thesis
Full Text:: restrained circular motion, closely following the water particle orbital motion under a simple wave

Hydrodynamic forces on a horizontal cylinder under waves and current

Creator:: Teng, Chung-chu
Abstract:: By assuming the linear superposition principle to be valid, the hydrodynamic forces on a horizontal cylinder under waves and current are examined. In this study, towing a cylinder in waves is used to simulate a cylinder under waves and current. The experimental technique is proved valid through theoretical considerations and...
Resource Type:: Masters Thesis
Full Text:: consideration of this study is the hydrodynamic force on a horizontal circular cylinder under waves and current

Seismic Retrofit of Square Reinforced Concrete Bridge Columns using Titanium Alloy Bars

Creator:: Shrestha, Sharoo
Abstract:: There are many aging bridges in service in the US and around the world that were not constructed to modern seismic design codes and standards. As a result, they are expected to perform poorly during intense earthquake ground shaking. Older reinforced concrete (RC) bridges, in particular, are often supported on...
Resource Type:: Dissertation

The effect of boundary geometry on internal density currents in a density stratified reservoir

Creator:: Spurkland, Torbjorn
Abstract:: The effects of boundary geometry on internal density currents in a density stratified reservoir were investigated in a laboratory model. When water was simultaneously withdrawn and admitted to the reservoir, a complex current regime was established. The general flow pattern is described, and the influence of physical variables on the...
Resource Type:: Masters Thesis
Full Text:: constant p and p are the maximum and minimum densities in max min the flowfield. For a circular

Evaluation of the torsion test for determining the shear strength of structural lumber

Creator:: Heck, Leanne Renee
Abstract:: The torsion test was evaluated as a method for determining the shear strength of full-size structural lumber. The evaluation involved an experimental length study, an experimental depth study, and a finite element study. The length study consisted of fifty nominal 2x4 specimens, ten specimens for each length, and ten American...
Resource Type:: Masters Thesis
Full Text:: . Torsion Theory 30 3.1 Circular prismatic bars 30 3.2 Rectangular prismatic bars 32 3.3 Prandtl's

The wastewater treatment characteristics of a rotating flighted cylinder

Creator:: Hansen, Larry Bruce
Abstract:: The rotating flighted cylinder (RFC) was investigated as a potential wastewater treatment deVice. A RFC is a rigid tube with a helically-wound fin attached to the interior surface and operates by flowing wastewater through the tube as it rotates. An 8-inch and 24-inch diameter RFC was tested for solids-liquid separation,...
Resource Type:: Masters Thesis
Full Text:: through a series of miniature settling basins partitioned by circular weirs acting as basin inlets and

ScholarsArchive@OSU

Wave forces on a horizontal circular cylinder near a plane boundary

The application of centrifugal modeling to determine ice forces on isolated circular structures

Behavior of cellular bulkheads in deep sands

Evaluation of Driver Behavior during Right Turn Maneuvers at Signalized Intersections: Mitigation of Driver-Pedestrian Conflicts with a Right Turn Flashing Yellow Arrow

Large scale model testing of the FMC submerged wave attenuation device

Hydrodynamic forces on a horizontal cylinder under waves and current

Seismic Retrofit of Square Reinforced Concrete Bridge Columns using Titanium Alloy Bars

The effect of boundary geometry on internal density currents in a density stratified reservoir

Evaluation of the torsion test for determining the shear strength of structural lumber

The wastewater treatment characteristics of a rotating flighted cylinder

Limit your search

Academic Affiliation

Advisor

Commencement Year

Committee Member

Creator

Contributor

Date

Decade

Degree Field

Degree Level

Degree Name

File Format

Language

License

Non-Academic Affiliation

Peer Reviewed

Resource Type

Rights Statement

Subject

Search Constraints

Search Results

Limit your search