Index Catalog // ScholarsArchive@OSU

A formal model of construction safety and health risk management

Creator:: Hallowell, Matthew R.
Abstract:: Despite recent efforts to improve site safety, construction still accounts for a disproportionate injury and illness rate. According to the 2007 injury and illness data released by the National Safety Council, the construction industry has a fatality and disabling injury rate that is approximately three times higher than the all-industry...
Resource Type:: Dissertation
Full Text:: Appendix H – Round 3 Delphi survey of capacity panel (partial) ……………… 307 Appendix I – Round 1 Delphi

A lagrangian philosophy for plume modeling

Creator:: Frick, Walter Eugen
Resource Type:: Dissertation

A method for quantifying macroporosity

Creator:: Vermeul, Vincent R.
Resource Type:: Masters Thesis
Full Text:: and representation with a single shape index (Clark, 1981). Davis (1986) tabulated a selection of

A Methodological Approach for Structural Health Monitoring of Mass-Timber Buildings Under Construction

Creator:: Baas, Esther J.
Abstract:: As mass-timber building construction rises around the globe, there exists the need to verify the long-term, in-situ behavior and performance of these structural systems. Structural health monitoring (SHM), generally defined as a damage detection strategy consisting of a network of sensors, a data acquisition system, and algorithms for data analysis,...
Resource Type:: Masters Thesis
Full Text:: you to Emily Davis for her enthusiasm in being involved in this project and assisting with data

A Multivariate Comparison of Drone-Based Structure from Motion and Drone-Based Lidar for Dense Topographic Mapping Applications

Creator:: Simpson, Chase H.
Abstract:: Unmanned aircraft systems (UAS), also known as drones, are an increasingly popular method of collecting surveying and mapping data. Two common drone-based mapping techniques are lidar and structure from motion (SfM) photogrammetry, and a frequently-heard (yet nearly impossible to answer) question is: “which is better?” The most common metric for...
Resource Type:: Masters Thesis
Full Text:: THESIS OF Chase H. Simpson for the degree of Master of Science in Civil Engineering presented on

A Regional-Scale Three-Dimensional Susceptibility Model for Enhanced Evaluation of Rainfall- and Seismically-Induced Landsliding

Creator:: Mathews, Nicolas
Abstract:: Shallow landslides are destructive natural hazards that result in widespread losses, both of infrastructure and lives, throughout the world. To help mitigate the impact of landslide hazards, they are commonly characterized across a regional scale by (1) their location and likelihood using susceptibility maps, (2) their magnitude and frequency using...
Resource Type:: Dissertation
Full Text:: for each row, from north to south; g) Landslide area density for each column, from west to east; h

A safety evaluation of turn lane-adjacent bike lane configurations in Portland, Oregon

Creator:: Wyman, Amy
Abstract:: The Manual on Uniform Traffic Control Devices prohibits positioning a bike lane right-adjacent to a vehicle turn-only lane to mitigate the potential for right-hook crashes. However, it provides no specific guidance on positioning with respect to bus-only lanes. This thesis describes a before/after safety evaluation of bike lanes positioned left...
Resource Type:: Masters Thesis

A treatise on structures without bending

Creator:: Taleb-Agha, Ghiath Abdul-Kareem
Abstract:: There are several factors which affect the cost and efficiency of a structure. The most important and basic factors are: the predominant stress, the way the structure carries the loads and the shape of the structure. The structures in which the predominant stress is not bending have been chosen to...
Resource Type:: Masters Thesis
Full Text:: Muriel Davis for Ghiath Abdul -Kareem Taleb -Agha TABLE OF CONTENTS Page INTRODUCTION 1 1. 1

Accuracy assessment of LiDAR point cloud geo-referencing

Creator:: Williams, Keith E.
Abstract:: Three-dimensional laser scanning has revolutionized spatial data acquisition and can be completed from a variety of platforms including airborne (ALS), mobile (MLS), and static terrestrial (TLS) laser scanning. MLS is a rapidly evolving technology that provides increases in efficiency and safety over static TLS, while still providing similar levels of...
Resource Type:: Masters Thesis
Full Text:: ea rc h C on st ru ct io n A ss et M an ag em en t To ur is m M ai nt en an ce R em

Accuracy, range, and convenience of certain methods and devices used in measurement of irrigation water

Creator:: Neu, Harold Wesley
Resource Type:: Masters Thesis
Full Text:: . H. Paul for her helpful interest and accurate typing. The authors whose works were consulted in

ScholarsArchive@OSU

A formal model of construction safety and health risk management

A lagrangian philosophy for plume modeling

A method for quantifying macroporosity

A Methodological Approach for Structural Health Monitoring of Mass-Timber Buildings Under Construction

A Multivariate Comparison of Drone-Based Structure from Motion and Drone-Based Lidar for Dense Topographic Mapping Applications

A Regional-Scale Three-Dimensional Susceptibility Model for Enhanced Evaluation of Rainfall- and Seismically-Induced Landsliding

A safety evaluation of turn lane-adjacent bike lane configurations in Portland, Oregon

A treatise on structures without bending

Accuracy assessment of LiDAR point cloud geo-referencing

Accuracy, range, and convenience of certain methods and devices used in measurement of irrigation water

Limit your search

Academic Affiliation

Advisor

Commencement Year

Committee Member

Creator

Contributor

Date

Decade

Degree Field

Degree Level

Degree Name

File Format

Language

License

Location

Non-Academic Affiliation

Peer Reviewed

Resource Type

Rights Statement

Subject

Search Constraints

Search Results

Limit your search