This thesis focuses on two aspects of transparent electronics, SnO₂ transparent thin-film transistors (TTFTs) and transparent circuits. Both depletion- and enhancement-mode SnO₂ TTFTs are realized. The maximum effective mobility for the depletion- and enhancement-mode devices are 2 cm²V⁻¹s⁻¹ and 0.8 cm²V⁻¹s⁻¹, respectively. A variety of techniques to decrease the carrier...
In recent years, a new class of high-performance thin-film transistors (TFTs) has emerged comprising amorphous oxide channel materials composed of heavy-metal cations (HMCs) with (n-1)d¹⁰ns⁰ (n ≥ 4, where 'n' refers to the row of the periodic table) electronic configuration. This thesis is devoted to the fabrication and characterization of...
At frequencies exceeding 1-2 GHz, the reactive nature of a silicon substrate must be accounted in the substrate network models used in substrate coupling simulation. High-frequency substrate models, containing reactive components, must be validated through high-frequency network analyzer measurements. Prior fabricated test fixtures have been modified to enable high-frequency (up...
The integration of renewable energy sources and the associated power electronics to notebook power and thermal management systems was investigated in this work. Both thermoelectric (TE) and photovoltaic (PV) energy extraction techniques were explored with the goal of achieving best sustainability. Semi-realistic usage assumptions were taken into account to evaluate...
Multiple-input multiple-output (MIMO) antenna technology is promising
for high-speed wireless communications without increasing the transmission band-
width. Space time coding (STC) is a scheme that employs multiple antennas to
increase transmission rate or to improve transmission quality. STC is used widely
in mobile cellular networks, wireless local area networks (WLAN)...
The amount of instruction level parallelism (ILP) that can be exploited depends
greatly on the size of the instruction window and the number of in-flight instructions
the processor can support. However, this requires a register file with a large set of
physical registers for renaming and multiple ports to provide...
Efficient methods for simulating the substrate noise generated by complex synchronous and asynchronous digital logic circuits are presented. By simulating digital logic at the gate level, and precharacterizing the gates, the substrate noise generation can be predicted and used in a transistor level simulation of the sensitive analog blocks. This...
Accurate scaled modeling and simulation are critical to advancing ocean wave linear generator buoys. A 100th scaled model of ocean wave generator buoy systems is analyzed by solving the Navier-Stokes equations. These equations are numerically solved using Computational Fluid Dynamics (CFD) by implementing the front capturing method. In this thesis,...
Ultra-wideband (UWB) communication has emerged as a very promising
technology for short-range wireless applications, including
high-speed multimedia transmissions and sensor networks. UWB
system designs involve many different aspects covering analog and
digital processing, channel estimation and modeling, and
modulation and demodulation. Although UWB still faces many
challenges, significant progress has...
Systems biology is becoming increasingly important for the study of living organisms. It focuses on the mathematical understanding of biological systems. Cells, the basic units of all living creatures, are biological systems of major interest. Considerable work is being done towards modeling cells as mathematical systems. At the same time,...
The purpose of this thesis is to explore methods which can reduce the power dissipation of a mobile system while decoding MPEG video. MPEG decoding is a microprocessor intensive process that makes heavy use of both the L1 and L2 caches as well as main memory. The heavy load placed...
A large number of sequential decision-making problems in uncertain environments
can be modeled as Markov Decision Processes (MDPs). In such settings, an agent
can observe at each time step the state of the environment and then executes an
action, causing a stochastic transition to a new state of the environment...
In this thesis, maximum likelihood Doppler frequency estimation and phase noise suppression algorithms for Orthogonal Frequency Division Multiplexing (OFDM) systems are presented. A novel handover decision algorithm for wireless systems, called predictive base station switching (PBSS), is also introduced.
The maximum Doppler Frequency is the ratio of the speed of...
Circuits operating outside the earth’s atmosphere are more vulnerable to cosmic radiation and require special design consideration. The purpose of this work is to explore methods of mitigating the effect of radiation in phase locked loop (PLL) circuits. Several voltage controlled oscillators (VCOs) and two complete PLLs are designed and...
The primary objective of the thesis research is to study novel schemes of on-chip crosstalk suppression employing magnetic films at microwave frequencies. Since extraction of various material properties of the magnetic films is essential for successful application of the proposed method, the research also involves development of a new material...
The world's oceans contain tremendous renewable energy potentials. It is estimated that if 0.2% of the ocean's untapped energy could be harnessed, it could provide power sufficient for the entire world [1]. This thesis provides a comprehensive description of the state-of-the-art of ocean energy extraction technologies and lessons learned from...
The world’s energy consumption is growing at an alarming rate and the need for renewable energy is apparent now more than ever. Estimates have shown that optimization of the extraction of energy from the ocean could significantly aid the world’s quest for sustainable and affordable energy services for all. From...
Wave energy conversion devices are a rapidly growing interest worldwide for the potential to harness a sustainable and renewable energy source. Due to the oscillatory nature of ocean waves, the power generated from a permanent magnet linear generator (PMLG) for ocean wave energy conversion is pulsed. Focusing on direct drive...
There is a large and growing market for portable consumer audio products
with very small size. As the size of these products is reduced, the area occupied
by batteries becomes significant and hence limits the number of batteries to one.
In order to build such small products, high levels of...
High performance multi-cell delta-sigma modulators are a preferred choice in applications which require programmability. Multi-cell delta-sigma modulators with M unit cells provide 10log10(M) SQNR improvement for the same thermal noise and bias power due to the uncorrelated quantization noises of the M unit ADCs. This concept is used in this...
This thesis presents new, compact configurations for RF/microwave bandstop and lowpass filters for embedded passive applications. A simple design methodology is presented for designing the folded-transmission line filters on a microstrip platform. Unlike the conventional stub-loaded filter designs, the proposed folded-line filters will have practical dimensions for a wide range...
Transmission over wireless networks presents multiple technical challenges due to
noise, interference, fading, power constraints and bandwidth limitation. Different
solutions have been propposed to overcome these issues and some of them are
treated here. Cooperative diversity has been proposed as an implementation for
networks where terminals are restricted to using...
Achieving sharpened (enhanced detail) features of a multi-dimensional data source using the linear prediction (LP) bandwidth extrapolation (BWE) technique in the transform domain is the main objective of this research. The evolution of sensor technology has provided acquisition scenarios in which the data format is inherently multi-dimensional, including hyperspectral imaging...
Orthogonal frequency division multiplexing (OFDM), which has been very attractive for future high rate wireless communications, is very robust to channel multipath fading effect while providing high transmission data rate with high spectral efficiency.
Multiple antennas can be combined with OFDM to increase diversity gain and to improve spectral efficiency...
Nowadays, error correction codes have become an integral part in almost all the modern digital communication and storage systems. With the continuously increasing demands for higher speed and lower power communication systems, efficient VLSI implementations of those error correction codes have great importance for practical applications. In this thesis, several...
With the growing demand for portable/consumer electronics, such as digital
audio/video (AV), the downscaling of device dimensions, which enables the
integration of an increasing number of transistors in a single chip, is mandatory.
This trend also continuously pushes the power supply voltage down to reduce the
power consumption and improve...
The demand for portable electronic systems and the continued
down-scaling of device dimensions resulted in rapid improvement in
the performance of integrated systems. Several low-voltage design
techniques have been proposed to operate analog circuits with sub-1V
supply. However, these techniques require higher power consumption
to achieve large dynamic range while...
Low-Density Parity-check (LDPC) codes have attracted considerable attention due to their capacity approaching performance over AWGN channel and highly parallelizable decoding schemes. They have been considered in a variety of industry standards for the next generation communication systems. In general, LDPC codes achieve outstanding performance with large codeword lengths (e.g.,...
To realize pipelined ADCs in deep-submicron processes, low voltage techniques
must be developed to work around problems created by limited supply voltages such as
the floating switch dead zone, reduced SNR, and reduced OpAmp performance.
This thesis analyzes standard and low voltage design issues for pipelined ADCs
and proposes a...
Power reduction can be achieved at many different levels, such as architecture, algorithm, logic, and transistor levels in circuit design. This thesis focuses on low power scheduling at the algorithm level. We present a latency-constrained scheduling and a latency and resource constrained scheduling, which minimize power consumption for the resources...
As the functionality of digital chips continues to increase dramatically, chip- to-chip communication bandwidths must scale accordingly to avoid constraining the overall system performance. Therefore, high speed transceiver design has be- come an important research topic. In particular, the performance of the circuits that are responsible for timing accuracy are...
The problem of locating a signal source, or an emitter, has many civilian and military applications, such as communication regulations enforcement, military reconnaissance, and search-and-rescue operations. Many of the most widely used emitter location methods rely on the accurate and robust estimation of the differential time delay,
or time-difference-of-arrival (TDOA),...
A significantly untapped renewable energy source exists in the world's oceans. It is estimated that if 0.2% of the ocean's untapped energy could be harnessed, it could provide power sufficient for the entire world. Ocean energy extraction is an old concept, and it is currently seeing the benefit of advancing...
Dynamic multithreaded processors attempt to increase the performance of a single
sequential program by dynamically extracting threads from sources such as loop
iterations. The scheduling of instructions in such a processor plays a vital role in the
amount of thread level parallelism that can be extracted and thus the overall...
The primary objective of this thesis is to explore new absorber and p-type window layer materials for thin-film solar cell applications. A new thin-film electron beam deposition system has been installed, is now operational, and has been used to deposit several types of solar cell absorber layers. Material investigations include...
Smart weapons promise to provide leap ahead capability with regard to accuracy and engagement range for medium and large caliber projectiles. One of the most critical components of a smart weapon system is its sensor suite that provides position, orientation, and velocity information as the projectile flies down range so...
The detection of motor faults at their incipient stage is of prime importance to any industrial plant. The introduction of adjustable speed drives has improved the control and the efficiency of induction motors, however, this has changed the nature of motor faults and how they can be detected.
Current signature...
Although the digital revolution can realize many of past analog components in the digital forms, our world is surrounded with analog signals such as voice, temperature, etc. The bridge between these two worlds is one of key performance limitations among overall systems and it includes analog filters and data converters....
Ultra-wideband (UWB) radio is the transmission of data using an extremely wide bandwidth and very low power spectral density. In this thesis, the mereits and challenges of UWB architectures versus conventional narrowband architectures will be compared. Pulsed UWB systems can be implemented with very simple architectures. These advantages make UWB...
In advanced hybrid electric vehicle development, performance and dependability are essential considerations in the design process. High efficiency is crucial in a successful design and fault tolerance is necessary to provide limp-home capability under faulted operating conditions. The reduction of electromagnetic interference is mandatory to reduce interference in communications and...
Ferrites have been used for various high frequency applications as bulk
materials. These applications, however, are limited to large dimension devices. In
this thesis, thin film ferrites were deposited from a low temperature solution-based
deposition process that is suitable for micro-scale high frequency applications. The
low temperature nature of this...
The substrate noise injected by a stepped buffer circuit into two single-ended 1.5GHz low noise amplifiers is examined for a heavily doped 0.25µm CMOS process. The difference in the LNA noise rejection is characterized as a function of the size and placement of substrate contacts. The use of a resistive...
End-user programmers, because they are human, make mistakes. However, past research has not considered how visual end-user debugging devices could be designed to ameliorate the effects of mistakes. This paper empirically examines oracle mistakes mistakes users make about which values are right and which are wrong to reveal differences in...
Continuously tunable diode laser sources coupled to single-mode fiber are useful sources for fiber Bragg grating (FBG) strain sensors. This paper describes the
development and fabrication of such a device. An introduction is given describing
applications of tunable lasers and some of the different methods of creating a tunable
diode...
The main contributions of this thesis are the development and
application of four computationally efficient solutions for
least-squares-based (LS-based) minimum variance spectral estimation
(MVSE). They are: (1) fast computational solution for the 1-D
covariance LS-based MVSE, (2) fast computational solution for the
1-D modified covariance LS-based MVSE, (3) fast computational...
Full dynamic control of physically simulated characters is the holy grail of video
games and other interactive applications. Recent advances in the field have
presented controllers that can handle the balance and fall response after a
collision. This thesis addresses the development of a controller that handles the
response before...
Digital-to-analog converters (DACs) suffer from static and dynamic nonlinearity problems, which degrade their accuracy and performance. Mismatch errors in the analog components restrict the maximum achievable linearity.
This thesis presents various techniques for correcting these errors. It describes a correction process for the nonlinear behavior of DACs, on three different...
Previous research has revealed gender differences that impact females’ willingness to adopt software features in end users’ programming environments. Since these features have separately been shown to help end users problem solve, it is important to female end users’ productivity that we find ways to make these features more acceptable...
Multiple-input multiple-output (MIMO) communication systems have recently been considered as one of the most significant technology breakthroughs for modern wireless communications, due to the higher spectral efficiency and improved link reliability. The sphere decoding algorithm (SDA) has been widely used for maximum likelihood (ML) detection in MIMO systems. It is...
Harvesting energy from the environment for powering micro-power devices have been increasing in popularity. These types of devices can be used in embedded applications or in sensor networks where battery replacement is impractical. In this dissertation, different methods of energy harvesting from the environment are explored as alternative sources of...