The objective of this thesis is to develop criteria for a data
acquisition system for electrical machinery capable of sampling a
signal every 0.2 msec with a desired accuracy of 0.1%. The system to
be measured includes both AC and DC voltage and current signals from
several points. The main...
The order of the practical system (e.g. nuclear power
plants, electrical power network and chemical plant) is
quite large. However, there are many limitations in computing
facilities for the large system. Because of these
limitations, it is often necessary to reduce the order of
the large system using an approximation....
This thesis presents a simulation technique for the
post-detection of a point-source trajectory in an
isotropic, stationary random medium. The two-dimensional
source location is estimated from spatially correlated
angle-of-arrival data which are collected simultaneously at
two sensor positions. We assume that the data are collected
at discrete, constant time intervals...
A circuit topology for high-swing, high-linearity
CMOS operational amplifiers has been developed. The
technique uses parallel-connected p- and n-channel
input pairs to realize an input common-mode voltage
range nearly equal to the total power supply voltage.
High linearity is achieved by summing the DC bias and
AC small-signal currents so...
The chopper-stabilized operational amplifier has good low
frequency noise properties. Unfortunately a simple technique for
simulation of the chopper-stabilized operational amplifier has
not been available.
This thesis describes the implementation of a differential
amplifier using chopper stabilization and its circuit modeling
for the SPICE simulation. This circuit has been designed...
This thesis discusses a special type of a versatile, distributed control system, the Taskmaster II. It includes a detailed specification of a readily realizable Taskmaster system utilizing a layered communication among units, oriented on the ISO OSI seven layer model. The specification was developed from the analysis of previous research...
Product quality control is the back bone for an efficient process control system. By monitoring the size of the board cut in a sawmill, performance of the production system can be controlled. Feedback from the quality control system is used to evaluate the status of the production system and also...
With increasing interest in current-mode analogue processing due to its high
performance properties such as speed, bandwidth and accuracy compared to voltage-mode
processing, new current-mode alternatives to various conventional circuit designs are
appearing. In this report, a novel circuit design to construct a fully-differential current-mode
operational amplifier ( OP-AMP )...
A new and improved stabilizer was developed for the variable speed generation (VSG) system. The VSG system exhibits periodic oscillations which sometimes leads to a loss of synchronism. After careful study, a simple but effective strategy to stabilize the system was implemented with real time digital feedback control. The VSG...
Brushless Doubly-Fed Machines have potential benefits in variable speed generation and adjustable speed drive applications by combining a robust machine structure with a reduced power converter rating. While recent work has demonstrated feasibility, steady-state performance has not been optimized. The nature of doubly-fed operation causes rotor currents of varying, relatively...