In recent years, there has been growing interest in both industry and academia to use continuous-time (CT) Δ-Σ A/D converters for wideband wireless and wireline communication applications.
So far no reported CT Δ-Σ A/D modulator achieves 14-bit or higher dynamic range (DR) with more than 2MHz signal bandwidth (equivalently 4MS/s)....
Traditionally linear actuator applications are addressed by the use of hydraulic systems. The high maintenance cost and poor reliability will always be the most critical problem in the real applications. Benefited from both the high mechanical advantage of the roll screw and the simple structure of the switched reluctance motor,...
This thesis presents a comparison of time-domain and frequency-domain algorithms for phase noise calculation in oscillators. Floquet theory provides the mathematical foundation for these calculations and the numerical methods employ perturbation projection vectors (PPVs). The PPVs are an estimate of an oscillator's sensitivity to noise.
The in-house circuit simulator SPICE3...
Designing spectral efficient, high-speed wireless links that offer high quality-
of-service and range capability has been a critical research and engineering challenge. In this thesis, we mainly address the complexity and performance issues of
channel estimation and data detection in multiple-input multiple-output (MIMO)
orthogonal frequency division multiplexing (OFDM) systems over...
Continuously tunable diode laser sources coupled to single-mode fiber are useful sources for fiber Bragg grating (FBG) strain sensors. This paper describes the
development and fabrication of such a device. An introduction is given describing
applications of tunable lasers and some of the different methods of creating a tunable
diode...
The purpose of this thesis is to explore dependency speculation in Dynamic Simultaneous Multi-Threading (DSMT). DSMT is a microprocessor architecture which attempts to extract Thread Level Parallelism (TLP) from single-threaded programs at run-time. This is accomplished by running multiple iterations of program loops in parallel. The DSMT architecture was originally...
There is a large and growing market for portable consumer audio products
with very small size. As the size of these products is reduced, the area occupied
by batteries becomes significant and hence limits the number of batteries to one.
In order to build such small products, high levels of...
Commonly proposed ocean wave energy converters (OWEC) use inefficient and maintenance demanding intermediate hydraulic and pneumatic systems. We propose a novel rotary direct-drive OWEC that eliminates these intermediate stages. The new device employs a contactless force transmission system (CFTS) comprising a “piston” and a “cylinder” and a ball screw to...
This thesis presents a Z-parameter based model to predict the substratenoise coupling between two contacts in a heavily doped substrate for frequenciesless than 2 GHz. The empirical model is scalable with contact size and spacingsbetween the contacts and model parameters can be readily extracted from simu-lated or measured data. The...
Recently, continuous-time ΔΣ modulators are appearing increasingly often in both the literature and the marketplace due to their features of inherent antialiasing and relaxed requirements for opamp and so on. However, several nonideal factors such as clock jitter, excess loop delay, inter-symbol interference and so on, degrade the SNR performance...