This research work focuses on the mechanism of 1/f noise in GaAs
resistors on semi-insulating substrates and 1/f noise due to temperature
fluctuations in heat conduction in resistors, diodes, and bipolar transistors. The
goal of this research is to generate accurate models to explain physical origin of 1/f
noise in...
A radix-based calibration technique was previously proposed with a two-stage algorithmic analog-to-digital converter (ADC). The objective of this work is to verify the capability of radix-based calibration for a true multi-stage ADC. In order to prove the idea, a single bit-per-stage, 20-stage pipelined ADC is designed in a 0.35-μm CMOS...
The passive charge compensation (PCC) technique was introduced for switched capacitor (SC) circuit to increase the slew rate and enhance the linearity performance, as PCC techniques are used on the Delta-Sigma modulator (DSM) in ADC circuitry. The PCC technique of the project was applied to the design of a SC...
As screen resolution and video decoding capability have increased, high-definition (HD) video in resolutions as high as 1920 x 1080 is rapidly becoming the standard. Ad-hoc streaming of HD video over 802.11 wireless networks, e.g., streaming from a mobile device to a television, is convenient for users, but is hampered...
Ring amplification has emerged as an efficient technique to drive large capacitive loads in switched capacitor circuits. We propose circuit techniques to demonstrate the first application of a ring amplifier in a non-capacitive feedback system of a LDO. These techniques enable a simple cap-less LDO structure in 180nm CMOS that...
Dynamic DC offset is one of the biggest problems preventing the implementation of single chip receivers. This thesis presents a 2.4GHz downconversion mixer designed to work with adaptive DC offset cancellation for a fully integrated direct conversion receiver. Offset can be removed by dynamically changing the PFET load bias in...
The increasing demand for higher data-rates is challenging to satisfy with spectrum-deficient indoor WiFi networks. A novel hybrid WiFi Free-Space Optical (WIFO) system has been proposed to enhance the wireless capacity of indoor WiFi networks. In this thesis, an integrated optical wireless receiver is designed and integrated in 65-nm CMOS...
The ability to accurately locate people and objects indoors will enable opportunities for control and automation of indoor environments. Current indoor localization solutions require dedicated hardware which must be custom tailored to each application. There are large technological, societal, and economic benefits in developing a more general purpose system that...
The sensors in real time data processing IoT devices require high resolution and sub-MHz data converters, usually implemented as Incremental ADCs due to the advantages of oversampling technique and low latency. In discrete time incremental (IDT) ADCs, the sampling switch non-linearity, charge injection degrade the resolution, and power hungry OPAMPs...
In cellular telephones, RF power amplifiers consume a significant part of the total phone current. Reducing the average PA current will extend battery life. In GSM systems the handset is commanded by the base station to transmit at power levels lower than full power much of the time. A Doherty...
In this thesis, we propose a Blockchain-based distributed protocol for enabling deployment of dynamic, on-demand IoT networks. Specifically, the proposed protocol leverages Blockchain technology to: (i) enable distributed and secure authentication, registration, and management of IoT devices; (ii) provide fast discovery of IoT resources and scalable and secure instantiation of...
A modeling technique for simulating the noise
performance of chopper-stabilized switched-capacitor
filters using SPICE2 is presented. A method for
selection of switched-capacitor network (SCN) stages
to be chopped and an op amp topology for low noise
applications are also outlined. Validity of the
modeling is verified by the close agreement...
Various natural language processing (NLP) tasks necessitate deep models that are fast, efficient, and small based on their ultimate application at the edge or elsewhere. While significant investigation has furthered the efficiency and reduced the size of these models, reducing their downstream latency without significant trade-offs remains a difficult task....
This thesis presents a channelized digital receiver design for UWB sytems in a multipath indoor environment. The UWB technology has been used for commercial and military purposes due to a number of advantages such as low-power consumption, noise-like and carrier free. The energy of UWB signal is spread over a...
The chopper-stabilized operational amplifier has good low
frequency noise properties. Unfortunately a simple technique for
simulation of the chopper-stabilized operational amplifier has
not been available.
This thesis describes the implementation of a differential
amplifier using chopper stabilization and its circuit modeling
for the SPICE simulation. This circuit has been designed...
A short-circuit-protected line-driver circuit is
particularly adapted for use in a CMOS differential line-driver
system, where one line-driver circuit provides a
true output signal, and another line-driver circuit
provides a complementary false output signal. A short-circuit
is sensed by measuring current through a secondary
pull-up transistor, and disabling a primary...
Various applications like wireless UWB communication, fast data acquisition systems and digital storage oscilloscopes needs ADCs with instantaneous input signal bandwidth from 0.1-40 GigaHertz range with 6-10 bits of resolution -- a challenging task and an impressive goal to achieve. Flash ADCs have been conventionally employed to achieve these goals...
AES (Advanced Encryption Standard), also known as Rijndael, is a symmetric key block cipher adopted as an encryption standard by the US government and used extensively in cryptographic applications worldwide. ARM is the most popular processor core used in embedded applications. This thesis surveys the available public implementations of AES...
Recently, continuous-time ΔΣ modulators are appearing increasingly often in both the literature and the marketplace due to their features of inherent antialiasing and relaxed requirements for opamp and so on. However, several nonideal factors such as clock jitter, excess loop delay, inter-symbol interference and so on, degrade the SNR performance...