Index Catalog // ScholarsArchive@OSU

A portable dual-range fuel flowmeter for automotive research

Creator:: Hodgkins, Chester
Abstract:: This describes the development of a new fuel flowmeter. Among the desired features were an accuracy of ±2%, a linear response to fuel flow rate, a means of increasing the sensitivity at the low end of the meter scale and portability so that it would be equally useful in the...
Resource Type:: Masters Thesis
Full Text:: . Referring to Figure 3, this proves to be 4. 25 x lO-6 trzl"ec at 9Oof . A sarnple calculation may be found

A study of compression loading of composite laminates

Creator:: Berbinau, Pierre J.
Abstract:: The compressive behavior of continuous fiber composites is not as well understood as their tensile behavior because research and industrial applications have until recently focused on the latter. Furthermore, most theoretical and experimental studies on the compression of composites have examined the case of unidirectional specimens with fibers along the...
Resource Type:: Dissertation

Thermal and seismic analysis of piping systems using classical methods

Creator:: Nisargand, Arun L.
Abstract:: "Piping Design and Engineering" first published in 1963 by Grinnell, Co. is widely used by engineers to perform approximate thermal stress analysis of high-temperature piping systems. The text consists of numerical constants to calculate end reactions and maximum bending stresses in a variety of piping configurations from known properties of...
Resource Type:: Masters Thesis
Full Text:: leg BC. nwL 2 MFAB MFBC 12 ' nwL 2 2E1m - -BC 12 L ( 2e B ) nwL 2 4E10 + B 12 L ec = 0 (6.1

Wind tunnel simulation and field measurements of flow over a coastal headland

Creator:: Brownlow, Roger West
Abstract:: An experimental study was made of the average and turbulent wind characteristics of the flow over a model of a coastal headland. The scale of the model was 300:1, corresponding to a prototype size of 500 m. The data for validation of the model study was obtained from instruments mounted...
Resource Type:: Dissertation
Full Text:: pressure e Energy Ec Eckert number Eu Euler number f Frequency - hertz Fr Froude number F(K /Ks

A model for the mechanical behavior of irradiated mixed carbide sphere pac fuel pins

Creator:: George, Thomas L.
Abstract:: A model is developed that allows the prediction of the stress-strain distribution in a mixed carbide sphere pac fuel pin during irradiation. The model is coupled with a previously developed model for the thermal behavior of the pin. The one-dimensional (radial at various axial locations) solution is for quasi-steady pin...
Resource Type:: Dissertation
Full Text:: , thermal expansion, creep and fission induced swelling giving 2.6 22 [E]-1 {Ep} {et} {Ec} {Es} {Een

Creep studies on Pheasant, Narcissus and Chukar aluminum conductors

Creator:: Patton, John Dennis
Abstract:: This thesis is an engineering report on the creep behavior of power transmission line conductors. Laboratory creep test results are reported for Pheasant, Narcissus and Chukar conductors. The report follows a standard nomenclature and format suggested by the International Study Committee No. 6 of Conference Internationale des Grands Reseaux Electriques...
Resource Type:: Masters Thesis
Full Text:: - aluminum conductors are fabricated from strands of EC grade aluminum, hard drawn to ASTM specification

Transient nonlinear deformations of viscoelastic membranes

Creator:: Jenkins, Christopher H. M.
Resource Type:: Dissertation

Performance of rotary regenerative heat exchanger--a numerical simulation

Creator:: Bae, Young Lib
Abstract:: This thesis examines the transient and steady-state temperature performance of a rotary regenerative heat exchanger. In contrast to previous studies on this problem, fluid flow in the circumferential direction was considered. Appropriate modeling was included to measure the effect of carry-over on the differential equations describing mass and energy conservation....
Resource Type:: Dissertation
Full Text:: capacity of interstitial fluid on the cold side, pp fcfLSc ec = heat capacity rate of the cold flow, pp

Comparison of European and American heavy machinery design, manufacturing, and economics influencing licensing agreements

Creator:: Gayer, George Frederick William
Resource Type:: Masters Thesis

Experimental studies of heat transfer with an array of horizontal tubes immersed in a high-temerature fluidized bed

Creator:: Goshayeshi, Ali
Abstract:: An experimental study is described in which time-average local heat transfer coefficients were obtained for arrays of horizontal tubes immersed in a hot fluidized bed. Spatial-averaged heat transfer coefficients, computed from local values, are also reported. Refractory particles with surface mean diameters of 2.14 mm and 3.23 mm were fluidized...
Resource Type:: Dissertation

ScholarsArchive@OSU

A portable dual-range fuel flowmeter for automotive research

A study of compression loading of composite laminates

Thermal and seismic analysis of piping systems using classical methods

Wind tunnel simulation and field measurements of flow over a coastal headland

A model for the mechanical behavior of irradiated mixed carbide sphere pac fuel pins

Creep studies on Pheasant, Narcissus and Chukar aluminum conductors

Transient nonlinear deformations of viscoelastic membranes

Performance of rotary regenerative heat exchanger--a numerical simulation

Comparison of European and American heavy machinery design, manufacturing, and economics influencing licensing agreements

Experimental studies of heat transfer with an array of horizontal tubes immersed in a high-temerature fluidized bed

Limit your search

Academic Affiliation

Advisor

Commencement Year

Committee Member

Creator

Date

Decade

Degree Field

Degree Level

Degree Name

Language

Non-Academic Affiliation

Peer Reviewed

Resource Type

Rights Statement

Subject

Search Constraints

Search Results

Limit your search