Advances in electronics fabrication, coupled with the demand for increased computing power, have driven the demand for innovative cooling solutions to dissipate waste heat generated by these devices. To meet future demands, research and development has focused on robust and stable two-phase heat transfer devices. A confined impinging jet is...
This thesis presents the results of an experimental
and analytical study of single-port buoyant turbulent jets
discharged into shallow water. The experimental results
include the measured downstream dilution, centerline
concentration and trajectory. Independent parameters
considered were Froude number, submerged depth, discharge
angle and velocity ratio.
Results indicate that decreasing the...
The effects of the orifice geometry and the surface boundary condition on the heat transfer distribution to a flat surface of an impinging jet array were investigated. The jet array impinged normally onto the surface which was either isothermal or had a uniform heat flux. The experiments were performed for...
The effect of jet flow pulsing and blowing ratio on a jet in cross flow has been investigated. Preliminary jet flow studies were performed without cross flow and an extensive study of jet with cross flow was done for a total of nine test cases. The effect of velocities ratios...
With continued development of the electronic industry, the demand for highly efficient heat removal solutions requires innovative cooling technologies. A computational fluid dynamic (CFD) study, including heat transfer, is performed for an axisymmetric, confined jet impingement experiencing boiling and coupled with vapor extraction. Boiling occurs at the target surface while...
The present study proposes to investigate the flow structure of different arrays of jets impinging on a flat surface enclosed by three walls, creating a channel that forces the air to leave in one preferential direction, generating a self sustain crossflow. Details of both the mean and some turbulence quantities...
Merging isothermal buoyant jets in a crossflow were investigated
experimentally. Jets of salt water were discharged from a constant
head tank into the stagnant tap water. A crossflow was simulated
by towing the discharge ports through the receiving water at desired
speeds. Visualization of the jet cross-sections produced by a...
Technologies such as avionics and power electronics are driving the demand for thermal management schemes towards high heat fluxes and low surface temperatures. Typically, these applications require the dissipation of heat fluxes in the rage of 100-1000 W/cm² while maintaining surface temperatures lower than about 85 °C. Phase-change heat transfer...