Index Catalog // ScholarsArchive@OSU

Creator:: Hainz, Leonard C.
Abstract:: A method for real time in-flight prediction of the ground impact point of an indirect fire projectile is investigated. The method investigated is comprised of a combination of an impact point predictor and an extended Kalman filter state estimator based on modified linear theory. The modified linear theory model is...
Resource Type:: Masters Thesis
Full Text:: . . . . . . . . . . . . . . . . . . . . . . . . . .. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ... 62 2 .14 Yaw rate versus range

Creator:: Wolochuk, Lee
Abstract:: A calorimeter capable of measuring the heat capacity of 1 mg size samples from 4.2 to greater than 100 K has been designed, constructed, and tested. The sample is bonded to the end of a 0.002 inch diameter, 0.5 cm long chromel-constantan thermocouple (type E) and heated optically with a...
Resource Type:: Masters Thesis
Full Text:: 1 e. 1 [ esits Afs e.A. J (10) where a = 5.67 X 10-8 W /m2K4; Ts = sample temperature; Ti

Creator:: Guo, Zhiqiang
Abstract:: Mechanical behavior of Nb-Ti superconducting composites with copper matrices have been studied experimentally and theoretically. Experimental work includes extensive measurements of Cu/Nb-Ti composite system. Techniques for fine fiber testing and composite wire measurement have been developed. Experimental parameters examined in this research include geometry, hardness, Young's modulus, Poisson's ratio, yield...
Resource Type:: Dissertation
Full Text:: Model 62 9.2 Analysis- 63 9.3 Results and Discussions 65 9.4 Conclusions- 68 10. CONCLUDING REMARKS 69

Creator:: Li, Xiao, 1963-
Abstract:: Part I discusses the development of an aluminum-magnesium-silicon alloy that may combine strength, extrudability, favorable corrosion resistance with low cost and scrap compatibility. The first part of the study determined the effects of small composition, heat treatment and mechanical processing changes on the ambient temperature tensile properties of the alloy....
Resource Type:: Dissertation
Full Text:: (Water quench). 37.5X. 120 61. Type II void of sample SS-35 (air cool). 50X. 121 62. Type II void

Creator:: Augustine, Frank Edward
Abstract:: A high volume sampling system, employing Nuclepore filters and designed for sampling particulate in the plumes from industrial sources using a light aircraft, is described. The effluent of kraft paper mills was sampled using this system and then analyzed by electron microscopy. Size distributions of particles were obtained at several...
Resource Type:: Dissertation

Creator:: Walker, Stel Nathan
Abstract:: Development of a performance analysis for propeller type wind turbines is presented. The analysis uses a strip theory approach that includes tip-loss and blade interference. A comparison is presented between analysis and test data. The comparison indicates that the analysis predicts wind turbine performance to an accuracy that is within...
Resource Type:: Dissertation
Full Text:: - = 4iirpV (l-a)aF (1.2. 2)dr dQ 3pV c2(l-a)a'F (1.2.3)- = 4iTrdr Thus in combination with blade element

ScholarsArchive@OSU