Index Catalog // ScholarsArchive@OSU

Improving part load efficiency of screw air compressors

Creator:: Maxwell, Jonathan B.
Abstract:: Air compressor systems are inefficient energy transfer devices even under the best of conditions, at full load. When only part load is required, efficiency drops further. This thesis attempts to improve part load efficiency of twin rotor screw air compressors in three ways. First, a guidebook was written to help...
Resource Type:: Masters Thesis
Full Text:: Abstract approved: George Wheeler Air compressor systems are inefficient energy transfer devices even

An experimental study of heat transfer to a horizontal tube in a large particle fluidized bed at elevated temperature

Creator:: George, Alan Herbert
Resource Type:: Dissertation
Full Text:: Herbert George for the degree of Doctor of Philosophy in Mechanical Engineering presented on June 4, 1981

Emissivity data for uranium dioxide

Creator:: Claudson, Thomas Tucker
Resource Type:: Masters Thesis
Full Text:: fol1owin equation may be derived. me (3) T TRB J2 1 . r----- ne - 1UB where: T true abìolute

Operation and maintenance procedures for improving compressed air system efficiency

Creator:: Bessey, Eric G.
Abstract:: Air compressors are a significant industrial energy user and therefore a prime target for industrial energy audits. The project goals were to develop a software tool, AIRMaster, develop a methodology for performing compressed air system audits, and conduct field audits to refine the methodology and assess savings potential from six...
Resource Type:: Masters Thesis
Full Text:: for Improving Compressed Air System Efficiency. Abstract approved: George M. Wheeler Air

Numerical study of flow maldistribution in microchannels using fully resolved simulation

Creator:: Martin, Mathieu Georges Charles
Abstract:: This thesis addresses numerical simulation of flow maldistribution in microchannels. Microchannels are often associated with two phase-flows which can generate many problems such as plugging the channel or perturbing the flow. In this study we have used CFD and fully resolved technique to simulate what would happen in the case...
Resource Type:: Masters Thesis
Full Text:: = U + Ω× r (3.13) where Mp is the mass of the body, Ip is the moment of inertia and r is the

Creep tests on single strand aluminum alloy conductor wire

Creator:: Croeni, Jack George
Resource Type:: Masters Thesis
Full Text:: CREEP PESTS ON SINGLE STRAND ALUMINiTM ALLOY CONDUCTOR ?/IR by JACK GEORGE CROEI A T}ThSIS

A model for the mechanical behavior of irradiated mixed carbide sphere pac fuel pins

Creator:: George, Thomas L.
Abstract:: A model is developed that allows the prediction of the stress-strain distribution in a mixed carbide sphere pac fuel pin during irradiation. The model is coupled with a previously developed model for the thermal behavior of the pin. The one-dimensional (radial at various axial locations) solution is for quasi-steady pin...
Resource Type:: Dissertation
Full Text:: carbide sphere pac fuel pins AN ABSTRACT OF THE THESIS OF Thomas L. George for the degree of Doctor of

Temperature effects on the mechanical properties of welds in three typical structural steels

Creator:: Marshall, Thomas George
Resource Type:: Masters Thesis
Full Text:: THREE TYPICAL STRUCTURAL STEELS by THOMAS GEORGE WRSHALL A THESIS submitted to OHEGON STATE

The effect of vacuum annealing on the impact properties of structural steel plate

Creator:: Gwin, George Andrew
Resource Type:: Masters Thesis
Full Text:: Aimealing Apparatus ........ 30 Figure 3. MachIned Specimens Before Fracture .. 32 Figure 4. ayari-R Steel

A numerical analysis of ice fog produced by automobiles

Creator:: Nelson, William George
Abstract:: A model of an exhaust plume was developed and programmed on a digital computer. The purpose of the model was to predict the concentration and size distribution of ice particles produced from automobile exhaust during arctic conditions. The model accounted for the nucleation, growth, and freezing of the condensed water...
Resource Type:: Dissertation
Full Text:: AN ABSTRACT OF THE THESIS OF WILLIAM GEORGE NELSON for the

ScholarsArchive@OSU

Improving part load efficiency of screw air compressors

An experimental study of heat transfer to a horizontal tube in a large particle fluidized bed at elevated temperature

Emissivity data for uranium dioxide

Operation and maintenance procedures for improving compressed air system efficiency

Numerical study of flow maldistribution in microchannels using fully resolved simulation

Creep tests on single strand aluminum alloy conductor wire

A model for the mechanical behavior of irradiated mixed carbide sphere pac fuel pins

Temperature effects on the mechanical properties of welds in three typical structural steels

The effect of vacuum annealing on the impact properties of structural steel plate

A numerical analysis of ice fog produced by automobiles

Limit your search

Academic Affiliation

Advisor

Commencement Year

Committee Member

Conference Name

Creator

Contributor

Date

Decade

Degree Field

Degree Level

Degree Name

File Format

Language

License

Non-Academic Affiliation

Peer Reviewed

Resource Type

Rights Statement

Subject

Search Constraints

Search Results

Limit your search