Endophytic fungi (A. coenophialum and A. lolii) which infect grasses produce ergot alkaloids that serve as the grasses' chemical defenses and enhance the vigor of the grass. Turf-type tall fescue with high endophyte levels has been deliberately developed to produce a greener, more vigorous, pest-resistant turf. Consumption of endophyte-infected grass...
The traditional filter paper assay for saccharifying cellulase
originally described by M. Mandels et al (1976) has been modified to
make possible low activity determinations of Trichoderma
cellulases. The enzymatic activity appears to decline during a
prolonged incubation period if no precautions have been taken. By
means of adding bovine...
The focus of this thesis is developing materials for thin-film transistors (TFTs). Cu₃SbS₄ is explored as p-channel layer. Cu₃SbS₄ TFTs show p-type, depletion-mode behavior with a small amount of gate-controlled modulation of the channel conductance. This behavior is consistent with Hall measurements indicating a mobility of 17 cm²V⁻¹s⁻¹ and hole...
The objective of this thesis is to provide an initial demonstration of two-terminal and three-terminal electronic devices employing amorphous multi-component metallic film
(AMMF) electrodes. Such a demonstration is successfully achieved in the fabrication of metal-insulator-metal (MIM) diode and hot electron transistor (HETs) structures employing ZrCuAlNi AMMF electrodes. The ultra-smooth surface...
Hydrated cobalt(II) and nickel(II) trifluoromethanesulfonates have
been prepared by a previously reported procedure, and have been
characterized for the first time as [ Co(H₂O)₆] (CF₃SO₃)₂H₂O and [Ni(H₂O)₆] (CF₃SO₃)₂. These formulations are based on analyses,
near-infrared spectra, and on measurements of the ligand field
electronic spectra and the magnetic susceptibilities. The...
The goal of this paper is to evaluate how synthetic lubricants perform in an enclosed gearbox application when compared with a proven mineral oil. This is in an effort to improve gearbox efficiency with the desired effect of lower emissions from of improved energy output from power generation. Four liquid...
Chainsaws serve as one of the primary tools used by logging corporations, ranches, and farms for forestry management. Lubricating oil remains one of the heaviest operational expenditures for chainsaws. This largely in part due to chainsaw lubrication being a total loss system in which nearly all lubricating oil applied is...
This study examines the self-reported behavior and ideals of a
sample of upper level managers, in relation to conflict management
with subordinates.
A survey developed by the author, which measures directive and
participative managerial behavior and ideals, was sent to a randomly
selected sample of 250 female and 250 male...
A method of locating electric transmission line towers using
ground survey data in a digital computer program is presented in this
thesis. The towers are located for maximum spacing subject to the
constraints of available tower heights, forbidden ground areas, minimum
ground clearance, and specified conductor tensions. The digital
method...
With advancements in CMOS technology, high speed analog circuits that were
traditionally implemented with discrete circuit components can now be made monolithically.
Antialiasing filters for video signals as well as signal conditioning filters in high
speed communication channels are examples of applications where high frequency integrated
circuits are now feasible....
Chainsaw users value cutting performance and safety. Knowledge of the forces exerted during sawing are necessary to understand and improve the cutting performance of saw chain. Additionally, cutting forces can be used to form metrics for evaluating performance tradeoffs when using a safety (i.e. low-kickback) saw chain versus a standard...
:
__________________________________________________________________
John P. Parmigiani
Chainsaw users value cutting performance and safety. Knowledge of
The pathogenesis, diagnosis and treatment of bacterial
dermatitis and various canine allergic dermatitidies including
allergic inhalant dermatitis, contact dermatitis and
flea allergy dermatitis were studied. The effect of specific
nonprotein and protein components of commercial flea
antigens on the gross and microscopic appearance of intradermal
injections was investigated. Additionally, a...
This thesis focuses on two aspects of transparent electronics, SnO₂ transparent thin-film transistors (TTFTs) and transparent circuits. Both depletion- and enhancement-mode SnO₂ TTFTs are realized. The maximum effective mobility for the depletion- and enhancement-mode devices are 2 cm²V⁻¹s⁻¹ and 0.8 cm²V⁻¹s⁻¹, respectively. A variety of techniques to decrease the carrier...
Controllable parameters in a power system include generator
terminal voltage, generator input power and network admittances.
These parameters can be controlled to damp
mechanical rotor oscillation in the generators and thereby
improve system transient stability. Explicit equations are
derived in this thesis for the control of these parameters to
introduce...
Neutron flux and gamma-ray dose have been measured in the
experimental facilities of the Oregon State TRIGA reactor.
Thermal neutron flux measurements utilized foil activation
techniques.
The gamma-ray dose was measured with a thermoluminescent
dosimetry system. The thermoluminescent material used was LiF.
Fast neutron spectrum measurements were performed. The
fast...
An algorithm for computing the parameter sensitivities of an excitation system for a hydroelectric generation system is developed for model analysis in this thesis. The IEEE Type 1 excitation system representation, linked with a simplified alternator and voltage regulator equivalent, provide a closed-loop model for digital simulation. Parametric sensitivities are...
The long-term goal of the research project initiated with this thesis is the development of lead-free, fully-transparent ferroelectric devices, such as ferroelectric capacitors or ferroelectric-gate field-effect transistors. Ferroelectric materials exhibit spontaneous polarization with the application of an external electric field, which is persistent upon removal of the applied field, and...
The long-term goal of this research project is the development of solution-based inorganic dielectric and semiconductor materials for inkjet printed electronics. The main focus of this thesis involves testing of the materials and devices under development. A new solution-based inorganic dielectric material (HfOSO₄), given the name hafsox, is developed and...
This thesis proposes a criteria for the evaluation of those variable
parameters that influence the response of a hydroelectric generator
driven by a hydraulic turbine of the Kaplan type. It is considered
a requirement that a unit must be stable when supplying an isolated
load and it is assumed that...
The focus of this thesis is the investigation of thin-film transistors (TFTs) based on amorphous oxide semiconductors (AOSs) in two circuit applications. To date, circuits implemented with AOS-based TFTs have been primarily enhancement-enhancement inverters, ring oscillators based on these inverters operating at peak frequencies up to ~400 kHz, and two-transistor...
The objective of this thesis is to provide an initial demonstration of the feasibility of constructing highly transparent active electronic devices. Such a demonstration is successfully achieved in the fabrication of ZnO-based thin film transistors (TFTs) exhibiting transparency greater than ~90% in the visible portion of the electromagnetic spectrum and...
Interest in nanomaterials is motivated partly by their potential for sensor arrays to detect
different gases. Nanowires in particular are of interest because their high surface-to-volume
ratio promises the possibility of high sensitivity. However, because of their discrete
quasi-one-dimensional geometry, electrical integration of nanowires into photolithographically
defined devices and circuits...
In this thesis, a digital computer method for locating transmission
line towers is presented. The computer program selects the
position of both angle and tangent type towers for a given ground profile.
This selection will provide a minimum cost per foot of
transmission line in terms of the average costs...
This thesis develops a simplified and logical simulation model
for an amplidyne excitation system for a synchronous generator with
an automatic voltage regulator.
The non-transfer function representation using field determined
parameters including variable inductance and machine saturation
was used to reduce the computing time for the stability analysis.
The simulation...
A method is developed for calculating the reactivity
worth of the heavy water coolant of the Plutonium
Recycle Test Reactor (PRTR). The coolant reactivity
worth is determined by calculating the effective multiplication
constant of the reactor core with and without
the coolant in given process tubes. The calculational
method includes...
The aim of the research undertaken for this thesis was to develop a new high-performance amorphous oxide semiconductor (AOS) for use as a channel layer in a thin-film transistor (TFT). AOS TFTs offer higher electron mobility than the established amorphous silicon based technology. A new channel material comprised of aluminum...
This simulation is a model for a tidal power-peaking plant that
can be used to determine the electrical peaking generation for a given
set of conditions.
The simulation internally contains a tide producing function
for a specific year, the hydraulic characteristics of the plant, and the
plant's machines' characteristics. The...
A prototype deep ocean nuclear moisture meter was developed
based on the detection of epithermal neutrons backscattered from
marine sediment molecules. Development consisted of choosing a
source, a detector, containment materials, and associated counting
equipment, followed by the construction and calibration of the probe.
Thermal neutron response of the probe...
The goal of this thesis study is to develop an activated reactive evaporation (ARE) system and to demonstrate its utility by fabricating-alternating current thin-film electroluminescent (ACTFEL) oxide phosphor devices. ARE entails evaporation in an activated gas. The main ARE system components are three thermal evaporation sources, a microwave power supply,...
The objective of this thesis is to contribute to the development of p-type materials for transparent electronics applications. Thin films of ®-BaCu2S2, a p-type semi-transparent semiconductor, are fabricated and characterized. ®-BaCu2S2 has a transmittance of 60% to 80 % in the visible portion of the electromagnetic spectrum. The mobility, conductivity,...
Movement intent decoders, which interpret volitional movement intent from human bioelectric signals, can be incorporated into modern neuroprostheses to offer people living with limb loss or paralysis the potential to regain their lost motor control. Machine learning methods have become the research standard for continuous decoders with high degrees of...
A low-energy, low-exposure-rate, guarded-field ionization
chamber system with a sensitive volume of approximately 1040 cm³ and an exposure-rate range from 60 mR/h to less than 0.5 mR/h
was designed, constructed and calibrated. The calibration was
effected by constructing and calibrating a 60 cm³ volume transfer
chamber of similar design against...
The capabilities of the Tektronix Model J2C/7J20 Rapid Scanning
Spectrometer for the determination of molecular species resulting from
Otto cycle combustion were experimentally investigated after a literature
search of the subject area. Combustion of hydrogen-air, carbon monoxideair,
and gasoline-air mixtures in the combustion chamber of a Cooperative
Fuel Research engine...
The tremendous growth of wireless and mobile communications has resulted in placing of stringent requirements on the channel spacing and, by implication, on the phase noise of oscillators, typically mandating the use of passive LC oscillators with high quality factor (Q). However the trend towards large-scale integration and low cost...
The objective of the work reported herein is to explore the impact of decreasing channel thickness on radio-frequency (RF) sputtered amorphous indium-gallium-zinc oxide (a-IGZO) thin-film transistors (TFTs) electrical performance through the evaluation of drain current versus gate voltage (I[subscript D] − V[subscript G]) transfer curves. For a fixed set of...
The feasibility of developing test circuits to perform in-circuit testing of analog
circuits is investigated in this thesis. A modular approach to analog testing has been
adopted. Accordingly, the testing of an operational amplifier, which is a basic building
block in analog circuits, is addressed. One convenient technique for measuring...
The importance of spectral efficiency in mobile communications often requires the use of non-constant-envelop linear digital modulation schemes. These modulation techniques carry signal information in both magnitude and phase, thus they must be linearly amplified to avoid nonlinear signal distortion which is not correctable in a typical receiver. A second...
In microwave network analysis, proper matching of the measurement system is necessary to prevent measurement errors and provide a
proper terminating impedance for the device-under-test. To obtain
this matching, a buffer amplifier is often used in the first stage of
the network analyzer.
This study describes the design and analysis...