Search Constraints

Start Over
Filtering by: Creator Sinden, J. A. Remove constraint Creator: Sinden, J. A. Degree Name Doctor of Philosophy (Ph.D.) Remove constraint Degree Name: Doctor of Philosophy (Ph.D.) Subject Analog-to-digital converters -- Design and construction Remove constraint Subject: Analog-to-digital converters -- Design and construction

Search Results

  • Design of a 14-bit continuous-time Delta-Sigma A/D modulator with 2.5MHz signal bandwidth

    Creator:
    Li, Zhimin
    Abstract:
    In recent years, there has been growing interest in both industry and academia to use continuous-time (CT) Δ-Σ A/D converters for wideband wireless and wireline communication applications. So far no reported CT Δ-Σ A/D modulator achieves 14-bit or higher dynamic range (DR) with more than 2MHz signal bandwidth (equivalently 4MS/s)....
    Resource Type:
    Dissertation
    Full Text:
    and Computer Engineering presented on January 27, 2006. Title: Design of a 14-bit Continuous-Time

  • Design of a 1.8-V 14-bit [delta] - [sigma] A/D converter with 8X oversampling and 4 MHz Nyquist output rate

    Creator:
    Jiang, Ruoxin
    Abstract:
    In this dissertation, a new Δ∑ A/D converter is presented that is ideally suited for communication applications. It is based on a single-loop single-stage structure, which can realize a high maximum out-of-band quantization noise gain while maintaining stable operation and thus achieve 14-bit resolution at 8 times oversampling. A fifth-order...
    Resource Type:
    Dissertation
    Full Text:
    '--p-- Delay Integrator *2 Quantizer J-1 ei FIGURE 2.2. Block diagram of a second-order L modulator

  • A wideband low-power continuous-time delta-sigma modulator for next generation wireless applications

    Creator:
    Chen, Xuefeng
    Abstract:
    Delta-Sigma (ΔΣ) analog-to-digital converters (ADCs) are widely used in wireless transceivers. Recently, continuous-time (CT) ΔΣ ADCs gain growing interest in wireless applications for their lower power consumption and wider input bandwidth as compared with the discrete-time (DT) counterparts. In this thesis, a wideband low-power CT ΔΣ modulator for next generation...
    Resource Type:
    Dissertation
    Full Text:
    ) where the �j are the roots of the characteristic equation Q(�) = 0. Fig. 3.4 shows the diagram of a

  • Micropower incremental analog-to-digital converters

    Creator:
    Chen, Chia-Hung
    Abstract:
    Incremental ADCs (IADCs) have many advantages for low-frequency high-accuracy data conversion—they are easy to multiplex between channels, need simpler digital decimation filter, and allow extended counting with a Nyquist-rate ADC. A single-loop incremental ADC was designed and fabricated in 90 nm for a biosensor interface circuit. It incorporates one integrator,...
    Resource Type:
    Dissertation
    Full Text:
    between channels, need simpler digital decimation filter, and allow extended counting with a Nyquist

  • Power Efficient Architectures for High Accuracy Analog-to-Digital Converters

    Creator:
    Zhang, Yi
    Abstract:
    Incremental ADCs (IADCs) have found wide applications in sensor interface circuitry since, compared to ∆Σ ADCs, they provide low-latency high-accuracy conversion and easy multiplexing among multiple channels. On the other hand, continuous-time ∆Σ ADCs (CTDSM) have been receiving more and more attention as a power-efficient solution in targeting medium to...
    Resource Type:
    Dissertation
    Full Text:
    due to a σj = 0.1%TS clock jitter versus the FIR tap length N, for both single-bit and 2-bit FIR DAC

  • Low-voltage data converters

    Creator:
    Meng, Qingdong
    Abstract:
    With the growing demand for portable/consumer electronics, such as digital audio/video (AV), the downscaling of device dimensions, which enables the integration of an increasing number of transistors in a single chip, is mandatory. This trend also continuously pushes the power supply voltage down to reduce the power consumption and improve...
    Resource Type:
    Dissertation
    Full Text:
    number of transistors in a single chip, is mandatory. This trend also continuously pushes the power

  • Low voltage switched capacitor circuits for lowpass and bandpass [delta sigma] converters

    Creator:
    Keskin, Mustafa
    Abstract:
    The most accurate method for performing analog signal processing in MOS (metal-oxide-semiconductor) integrated circuits is through the use of switched-capacitor circuits. A switched-capacitor circuit operates as a discrete-time signal processor. These circuits have been used in a variety of applications, such as filters, gain stages, voltage-controlled oscillators, and modulators. A...
    Resource Type:
    Dissertation
    Full Text:
    -oxide-semiconductor) integrated circuits is through the use of switched- capacitor circuits. A switched

  • Architectural Solutions for Analog Imperfections in ΔΣ Analog-to-Digital Based Systems

    Creator:
    Zali Asl, Samira
    Abstract:
    For today’s ubiquitous portable devices, innovative integrated circuits with high performance yet very low power are necessary. As these devices are used to communicate and sense real world signals in the environment, analog-to-digital converters (ADC) and systems are the key interface circuits needed to digitize the sensed information and they...
    Resource Type:
    Dissertation
    Full Text:
    non-linearity. In this approach, a multi-loop delta-sigma (ΔΣ) ADC architecture is introduced that

  • Low-power high-resolution delta-sigma ADC design techniques

    Creator:
    Wang, Tao
    Abstract:
    This dissertation presents a low-power high-resolution delta-sigma ADC. Two new architectural design techniques are proposed to reduce the power dissipation of the ADC. Compared to the conventional active adder, the direct charge transfer (DCT) adder greatly saves power by keeping the feedback factor of the active adder unity. However, the...
    Resource Type:
    Dissertation
    Full Text:
    dissertation. Reference [1-1] N. Verma, A. Shoeb, J. Bohorquez, J. Dawson, J. Guttag, and A. P

  • Energy and area efficient techniques for data converters

    Creator:
    Venkatram, Hariprasath
    Abstract:
    Data converters are ubiquitous building blocks of a signal chain. The rapid increase in communication and connectivity devices presents new avenues for pushing the state of the art analog to digital converters. Techniques for improving resolution, bandwidth, linearity and bit-error rate, while reducing the power, energy and area is the...
    Resource Type:
    Dissertation
    Full Text:
    approved: Un-Ku Moon Data converters are ubiquitous building blocks of a signal chain. The rapid increase

  • Design techniques for wideband low-power Delta-Sigma analog-to-digital converters

    Creator:
    Wang, Yan
    Abstract:
    Delta-Sigma (ΔΣ) analog-to-digital converters (ADCs) are traditionally used in high quality audio systems, instrumentation and measurement (I&M) and biomedical devices. With the continued downscaling of CMOS technology, they are becoming popular in wideband applications such as wireless and wired communication systems,high-definition television and radar systems. There are two general realizations...
    Resource Type:
    Dissertation
    Full Text:
    radar systems. There are two general realizations of a ΔΣ modulator. One is based on the discrete-time

  • Design of low OSR, high precision analog-to-digital converters

    Creator:
    Rajaee, Omid
    Abstract:
    Advances in electronic systems have lead to the demand for high resolution, high bandwidth Analog-to-Digital Converters (ADCs). Oversampled ADCs are well- known for high accuracy applications since they benefit from noise shaping and they usually do not need highly accurate components. However, as a consequence of oversampling, they have limited...
    Resource Type:
    Dissertation
    Full Text:
    . However, as a consequence of oversampling, they have limited signal bandwidth. The signal bandwidth (BW

  • High efficiency delta-sigma modulation data converters

    Creator:
    Lee, Kyehyung
    Abstract:
    Enabled by continued device scaling in CMOS technology, more and more functions that were previously realized in separate chips are getting integrated on a single chip nowadays. Integration on silicon has opened the door to new portable wireless applications, and initiated a widespread use of these devices in our common...
    Resource Type:
    Dissertation
    Full Text:
    that were previously realized in separate chips are getting integrated on a single chip nowadays

  • Design techniques for low-voltage and low-power analog-to-digital converters

    Creator:
    Ahn, Gil Cho
    Abstract:
    With the ever-increasing demand for portable devices used in applications such as wireless communication, mobile computing, consumer electronics, etc., the scaling of the CMOS process to deep submicron dimensions becomes more important to achieve low-cost, low-power and high-performance digital systems. However, this downscaling also requires similar shrinking of the supply...
    Resource Type:
    Dissertation
    Full Text:
    are proposed. The specific research contributions of this work include (1) introduction of a new low

  • Design techniques for low power ADCs

    Creator:
    Yu, Wenhuan
    Abstract:
    This dissertation presents an incremental analog-to-digital converter (ADC) with digital digital-to-analog converter (DAC) mismatch correction. A theoretical time-domain analysis technique was developed to predict the noise performance of the incremental ADC, and a new optimization technique was proposed to minimize the output noise. In the calibration mode, the incremental ADC...
    Resource Type:
    Dissertation
    Full Text:
    multiplexed incremental ADCs, and presents a new analysis technique (proposed by J. Steensgaard) for

  • Low-power design techniques for low-voltage analog-to-digital converters

    Creator:
    Kim, Min Gyu
    Abstract:
    The demand for portable electronic systems and the continued down-scaling of device dimensions resulted in rapid improvement in the performance of integrated systems. Several low-voltage design techniques have been proposed to operate analog circuits with sub-1V supply. However, these techniques require higher power consumption to achieve large dynamic range while...
    Resource Type:
    Dissertation
    Full Text:
    technique is low-voltage double-sampling method for delta-sigma analog-to-digital converters using a

  • High-performance delta-sigma analog-to-digital converters

    Creator:
    da Silva, Jose Barreiro
    Abstract:
    Multi-stage delta-sigma (ΔΣ) architectures, commonly known as MASH, are the preferred choice for analog-to-digital converters (ADCs) used in broadband communication applications, where high-resolution (above 14 bits) and high-bandwidth (several MHz) performances are required. Current state-of-the-art designs are capable of as much as 5-MS/s output data rates with 90-dB SNR. However,...
    Resource Type:
    Dissertation
    Full Text:
    . PDF I 2B1 V15/2 q (a) PSD j/2 172 f (b) Figure 2.7: Probability density function and power

  • Automated verilog-to-layout synthesis of ADCs using custom analog cells

    Creator:
    Waters, Allen
    Abstract:
    A procedure for automating the design and layout of analog-to-digital converters (ADCs) is presented. This procedure makes use of the existing synthesis and place-and-route tools that are common in digital circuit design. A method for adding rudimentary analog cells to the standard library is described, allowing the designer to synthesize...
    Resource Type:
    Dissertation
    Full Text:
    : Automated Verilog-to-Layout Synthesis of ADCs Using Custom Analog Cells. Abstract approved: Un-Ku Moon A

  • Adaptive, wideband analog-to-digital conversion for convergent communication systems

    Creator:
    Batten, Robert D., 1973-
    Abstract:
    The exponential rate of advances in modern communication devices in the last several years have brought us higher levels of functionality and performance as well as reductions in physical size and power consumption. To continue this rate of advancement, next generation systems require wider bandwidth and higher resolution ADCs. Additionally,...
    Resource Type:
    Dissertation
    Full Text:
    n M o v i n g O b j e c t De tec t i on I Q X X A D C A D C D S P U s e r I n t e r

  • Automated synthesis of analog to digital conversion

    Creator:
    Weaver, Skyler
    Abstract:
    This thesis describes circuit architectures and techniques that facilitate the automatic synthesis and fabrication of analog-to-digital converters (ADCs). Since automated synthesis already exists for digital circuits and is part of the digital circuit design flow, this work demonstrates the feasibility of ADC synthesis with little or no modification to presently...
    Resource Type:
    Dissertation
    Full Text:
    ADC can be as automatic and straightforward as a standard digital circuit. c©Copyright by Skyler