Index Catalog // ScholarsArchive@OSU

Simulation of coastal processes in a circular wave basin

Creator:: Katzev, David H.
Abstract:: The circular wave basin provides a means of physically modeling the nearshore without the typical problems associated with end walls. Three different coastal processes were examined to demonstrate the use of a spiral wavemaker in a circular wave basin. These were longshore currents, shear waves, and groin circulation. A beach...
Resource Type:: Masters Thesis
Full Text:: Simulation of coastal processes in a circular wave basin

Friction losses for water flowing in non-circular ducts

Creator:: Mohandes, Abdolhosein
Abstract:: Friction factors were measured for water flowing in ducts made up of two rods held between two flat plates. Three rod diameters of 0.50, 1.00 and 1.50 inches were used. The spacings between rods varied from 0.0 to 0.32 inch. It was found that the concept of hydraulic diameter was...
Resource Type:: Masters Thesis
Full Text:: Friction losses for water flowing in non-circular ducts

Structural stability effects on adsorption of bacteriophage T4 lysozyme to colloidal silica

Creator:: Tian, Minghua
Abstract:: Circular dichroism (CD) spectra were obtained for bacteriophage T4 lysozyme and three of its mutants in the presence and absence of colloidal silica nanoparticles. Mutant lysozymes were produced by substitution of the isoleucine at position 3 with tryptophan, cysteine and leucine. Each substitution resulted in an altered structural stability, quantified...
Resource Type:: Masters Thesis
Full Text:: Adsorption of Bacteriophage T4 Lysozyme to Colloidal Silica Abstract approved by: Circular dichroism (CD

Evaluation of remediation techniques for circular holes in the webs of wood I-joists

Creator:: Polocoser, Tiberiu
Abstract:: The objective of this project was to evaluate methods to remediate a wood I-joist with a single, circular hole in the web while leaving utilities in place. The methods were experimentally evaluated with a full-scale bending test using four equally spaced point loads. There were three depths of joists with...
Resource Type:: Masters Thesis
Full Text:: 2012 Title: Evaluation of Remediation Techniques for Circular Holes in the Webs of Wood I- Joists

The asymptotic boundary layer on a circular cylinder in axisymmetric micropolar fluid flow and constitutive theories

Creator:: Okada, Kanzo
Abstract:: The asymptotic boundary layer problem involving an axial incompressible Newtonian fluid flow past a circular cylinder parallel to its axis was investigated by Stewartson (1955). He addressed hiself primarily to the Mangler's (1948) derivation, namely, the character of the boundary layer on a circular cylinder is equivalent to that on...
Resource Type:: Masters Thesis
Full Text:: The asymptotic boundary layer on a circular cylinder in

A calculation of the suction requirements to prevent boundary layer separation on a circular cyclinder

Creator:: Corsiglia, Victor R.
Abstract:: An investigation was made to test the method of Head on the flow about a circular cylinder with suction. The method of Head is an approximate method of obtaining solutions to the boundary layer equations. The method was adapted to the digital computer to facilitate performing the calculations, and a...
Resource Type:: Masters Thesis
Full Text:: CIRCULAR CYLINDER Abstract approved (Major professor) An investigation was made to test the method of

Fluid forces on and flow configurations around a circular cylinder near a plane boundary

Creator:: Tavolacci, Don
Abstract:: The flow configurations around and the forces acting on a circular cylinder with its axis parallel to a nearby plane boundary and subjected to a uniform flow were investigated. The flow conditions, which were perpendicular to the cylinder axis and parallel to the plane boundary were investigated experimentally and theoretically....
Resource Type:: Masters Thesis
Full Text:: Fluid forces on and flow configurations around a circular

Pressure distribution around a circular cylinder resting on a flat boundary in an oscillating fluid

Creator:: Johnson, Ronald Ernest
Abstract:: This study was undertaken to provide information needed in the design of ocean outfalls. A review of past investigations concerning forces on submerged objects is presented. Objects independent of any boundary and cylinders in boundary contact are considered. A solution for pressure distribution about a circular cylinder resting on a...
Resource Type:: Masters Thesis
Full Text:: Pressure distribution around a circular cylinder resting

Monte Carlo simulation of radiation heat transfer in a three-dimensional enclosure containing a circular cylinder

Creator:: Hong, Seung-Ho
Resource Type:: Masters Thesis
Full Text:: three-dimensional enclosure containing a circular cylinder AN ABSTRACT OF THE THESIS OF Seung-Ho Hong

The application of centrifugal modeling to determine ice forces on isolated circular structures

Creator:: Clough, Herbert F.
Abstract:: A test system was developed and used to investigate ice/structure interaction with centrifugal modeling. The test system was designed to perform two main functions: (1) create a uniform ice sheet, and (2) drive a model structure through the ice sheet at a constant speed. Both of these functions were required...
Resource Type:: Masters Thesis
Full Text:: forces on isolated circular structures AN ABSTRACT OF THE THESIS OF Herbert F. Clough for the degree

ScholarsArchive@OSU

Simulation of coastal processes in a circular wave basin

Friction losses for water flowing in non-circular ducts

Structural stability effects on adsorption of bacteriophage T4 lysozyme to colloidal silica

Evaluation of remediation techniques for circular holes in the webs of wood I-joists

The asymptotic boundary layer on a circular cylinder in axisymmetric micropolar fluid flow and constitutive theories

A calculation of the suction requirements to prevent boundary layer separation on a circular cyclinder

Fluid forces on and flow configurations around a circular cylinder near a plane boundary

Pressure distribution around a circular cylinder resting on a flat boundary in an oscillating fluid

Monte Carlo simulation of radiation heat transfer in a three-dimensional enclosure containing a circular cylinder

The application of centrifugal modeling to determine ice forces on isolated circular structures

Limit your search

Academic Affiliation

Advisor

Commencement Year

Committee Member

Conference Name

Conference Section/Track

Creator

Contributor

Date

Decade

Degree Field

Degree Level

Degree Name

File Format

Funding Body

Language

License

Location

Non-Academic Affiliation

Peer Reviewed

Resource Type

Rights Statement

Subject

Search Constraints

Search Results

Limit your search