Index Catalog // ScholarsArchive@OSU

Creator:: Liska, J. A. and Forest Products Laboratory (U.S.)
Abstract:: Information reviewed and reaffirmed March 1956.
Resource Type:: Technical Report
Full Text:: thick on the lower facing. The facings on floor P were of FS-lh magnesium alloy 0.090 inch thick on the

Creator:: Johnson, L. F. and Forest Products Laboratory (U.S.)
Abstract:: Information reviewed and reaffirmed March 1956. Original report issued April 1949.
Resource Type:: Technical Report
Full Text:: . The upper or wearing surface of floor Pp was FS-1A magnesium alloy 0.090 inch thick, and that of floor

Creator:: Liska, J. A. and Forest Products Laboratory (U.S.)
Resource Type:: Technical Report
Full Text:: assembled from five configurations of magnesium alloy extrusions. Teets simulating loads applied in ser

Creator:: Forest Products Laboratory (U.S.) and Eickner, Herbert W.
Abstract:: This report is one of a series issued in cooperation with the ANC-23 Panel on Sandwich Construction of the Departments of the Air Force, Navy, and Commerce.
Resource Type:: Technical Report
Full Text:: was controlled to be 0.50 ± 0.01 inch. AZ31-H24, formerly designated as FS1-1-124,magnesium alloy

Creator:: Liska, J. A. and Forest Products Laboratory (U.S.)
Abstract:: Information reviewed and reaffirmed January 1959. Original report issued June 1948.
Resource Type:: Technical Report
Full Text:: .--' _' The two floors tested, designated R and S / were aluminum-alloy floors having a flat sheet-aluminum

Creator:: Yolton, L. A. and Forest Products Laboratory (U.S.)
Resource Type:: Technical Report
Full Text:: dimpled aluminum-alloy sheet. These two sheets were spot-welded to a dimpled-sheet base formed to

Creator:: Yolton, L. A. and Forest Products Laboratory (U.S.)
Abstract:: Information reviewed and reaffirmed March 1956. Original report issued October 1946.
Resource Type:: Technical Report
Full Text:: earlier reportl. Floor L consists essentially of an aluminum alloy sheet formed to typical rounded

Creator:: Forest Products Laboratory (U.S.) and Eickner, Herbert W.
Abstract:: This report is one of a series issued in cooperation with the Air Force-Navy-Civil Subcommittee on Aircraft Design Criteria under the supervision of the Aircraft Committee of the Munitions Board. Information reviewed and reaffirmed March 1956 and 1962. Original report issued December 1950.
Resource Type:: Technical Report
Full Text:: A STUDY OF METHODS FOR PREIPAVING CLAD 24S-T ALUMINUM-ALLOY SHEET

Creator:: Forest Products Laboratory (U.S.), Eickner, Herbert W., and Schowalter, W. E.
Abstract:: This report is one of a series issued in cooperation with the Air Force-Navy-Civil Subcommittee on Aircraft Design Criteria under the supervision of the Aircraft Committee of the Munitions Board.
Resource Type:: Technical Report
Full Text:: A STUDY CF METHODS FOR !PREPARING CLAD 24S-T3 ALUMINUM-ALLOY SHEET

Creator:: Liska, J. A. and Forest Products Laboratory (U.S.)
Abstract:: Information reviewed and reaffirmed March 1956. Original report published October 1948.
Resource Type:: Technical Report
Full Text:: cotton duck honeycomb core and 24ST aluminum alloy facings. The only difference in construction is the

ScholarsArchive@OSU