Search Constraints

Start Over
Filtering by: Subject Cutting tools Remove constraint Subject: Cutting tools Language English [eng] Remove constraint Language: English [eng]

Search Results

  • Determination of cutting forces with asymmetric wedged blades

    Creator:
    Phan, Andrew Vinh
    Abstract:
    Cutting operations using blades appear in several different industries such as food processing, surgical operations, gardening equipment, and so forth. As our society continues to increase our technological prowess, there is an ongoing need to better understand the underlying causes of simple tasks such as cutting so that cutting operations...
    Resource Type:
    Masters Thesis
    Full Text:
    advancement of cutting tool technology. The factor that is almost always attributed to the performance of a

  • An analysis of peripheral milling of finger-joints in ponderosa pine cut-stock

    Creator:
    Liu, Yongsheng
    Abstract:
    To make low grade lumber into high-valued products, finger-jointing is a widely used method in the timber industry. In certain situations, chip-out occurs degrading the quality of the joint. To better understand the machining process, a beam-type dynamometer based on strain gages was designed to analyze the dynamic cutting forces...
    Resource Type:
    Masters Thesis
    Full Text:
    . Slight differences in tool shape and the balance of the cutterhead can vary the cutting force behavior

  • Drilling process evaluation by predicting drilled hole quality and drill bit wear with on-line acoustic emission signals

    Creator:
    Wang, Kuang-Jen, 1962-
    Abstract:
    Improvement of manufacturing productivity is dependent on the successful automation of manufacturing processes, the success of which is based in turn upon the availability of information which describes the state of manufacturing operations. Acoustic Emission (AE) signals related to the cutting process and tool wear have been recently applied to...
    Resource Type:
    Dissertation
    Full Text:
    ) signals related to the cutting process and tool wear have been recently applied to monitor manufacturing