A study was conducted to determine the heat transfer characteristics
of pin finned heat sinks in natural convection. Three pin
diameters were studied: 0.238 cm, 0.318 cm and 0.396 cm. The pins
were attached to the base in two arrangements, triangular and
rectangular, forming a horizontal array. Pin spacing was...
The ever increasing requirements for heat dissipation in various thermal management applications such as computer chip cooling and high power electronics have necessitated the need for novel thermal management techniques. Thermal management using heat sinks with microscale features is amongst the prominent techniques developed over the past two decades. In...
Advances in electronics fabrication, coupled with the demand for increased computing power, have driven the demand for innovative cooling solutions to dissipate waste heat generated by these devices. To meet future demands, research and development has focused on robust and stable two-phase heat transfer devices. A confined impinging jet is...
This thesis discusses the design of several microchannel solar receiver devices for use in CSP (concentrated solar power) using CFD (computational fluid dynamics) simulations. The goal is to demonstrate that, by taking advantage of the higher heat transfer coefficienct of microchannels, solar receivers can achieve higher efficiency than current receiver...
Heat transfer from a vertical flat plate in an infinite pool of
mercury was investigated. Velocity profiles were measured with a
hot-film anemometer and simultaneous temperature profiles measured
with thermocouples in this low Prandtl number liquid metal. Constant
heat flux plates at Grashof numbers of 9 x 10⁸ and 4...
An analytical model of the radiative contribution to the
total heat transfer between a large-particle (greater
than 1 mm) gas-fluidized bed and an immersed horizontal
tube is discussed. The model is applied to the case of a
bubbling bed and the emulsion phase contribution is obtained from a detailed analysis...
Heat transfer and fluid mechanical behavior of water
flowing horizontally in vertically-narrow rectangular
channels was studied in this work. Friction factor and
Nusselt number variations were determined experimentally
for four different wall heating conditions, and for aspect
ratios(height to width) of 5, 4, 3, 2, and 1. Wall
heating conditions...
An experimental investigation was conducted for natural convection
heat transfer in an array of uniformly heated vertical cylinders
in mercury. The test section consisted of seven electrically heated
cylinders of 1.365 inch diameter and 3.825 inch heated length
arranged in an equilateral triangular pattern. In order to preclude
side flow...
Production of surimi represents a potential utilization of a number of low-valued
fish species, one of which, Pacific whiting, represents the largest biomass off the West
Coast of the United States. However, a protease enzyme softens the fish flesh in Pacific
whiting and limits the expansion of surimi production.
Many...