Search Constraints

Start Over
Filtering by: Non-Academic Affiliation Oregon State University. Graduate School Remove constraint Non-Academic Affiliation: Oregon State University. Graduate School Resource Type Dissertation Remove constraint Resource Type: Dissertation Subject Analog-to-digital converters -- Design and construction Remove constraint Subject: Analog-to-digital converters -- Design and construction

Search Results

  • Power Efficient Architectures for High Accuracy Analog-to-Digital Converters

    Creator:
    Zhang, Yi
    Abstract:
    Incremental ADCs (IADCs) have found wide applications in sensor interface circuitry since, compared to ∆Σ ADCs, they provide low-latency high-accuracy conversion and easy multiplexing among multiple channels. On the other hand, continuous-time ∆Σ ADCs (CTDSM) have been receiving more and more attention as a power-efficient solution in targeting medium to...
    Resource Type:
    Dissertation

  • Architectural Solutions for Analog Imperfections in ΔΣ Analog-to-Digital Based Systems

    Creator:
    Zali Asl, Samira
    Abstract:
    For today’s ubiquitous portable devices, innovative integrated circuits with high performance yet very low power are necessary. As these devices are used to communicate and sense real world signals in the environment, analog-to-digital converters (ADC) and systems are the key interface circuits needed to digitize the sensed information and they...
    Resource Type:
    Dissertation

  • Wideband discrete-time delta-sigma analog-to-digital converters with shifted loop delays

    Creator:
    Meng, Xin
    Abstract:
    Low-distortion architecture is widely used in wideband discrete-time switched-capacitor delta-sigma ADC design. However, it suffers from the power-hungry active adder and critical timing for quantization and dynamic element matching (DEM). To solve this problem, this dissertation presents a delta-sigma modulator architecture with shifted loop delays. In this project, shifted loop...
    Resource Type:
    Dissertation

  • Automated verilog-to-layout synthesis of ADCs using custom analog cells

    Creator:
    Waters, Allen
    Abstract:
    A procedure for automating the design and layout of analog-to-digital converters (ADCs) is presented. This procedure makes use of the existing synthesis and place-and-route tools that are common in digital circuit design. A method for adding rudimentary analog cells to the standard library is described, allowing the designer to synthesize...
    Resource Type:
    Dissertation

  • Micropower incremental analog-to-digital converters

    Creator:
    Chen, Chia-Hung
    Abstract:
    Incremental ADCs (IADCs) have many advantages for low-frequency high-accuracy data conversion—they are easy to multiplex between channels, need simpler digital decimation filter, and allow extended counting with a Nyquist-rate ADC. A single-loop incremental ADC was designed and fabricated in 90 nm for a biosensor interface circuit. It incorporates one integrator,...
    Resource Type:
    Dissertation

  • Energy and area efficient techniques for data converters

    Creator:
    Venkatram, Hariprasath
    Abstract:
    Data converters are ubiquitous building blocks of a signal chain. The rapid increase in communication and connectivity devices presents new avenues for pushing the state of the art analog to digital converters. Techniques for improving resolution, bandwidth, linearity and bit-error rate, while reducing the power, energy and area is the...
    Resource Type:
    Dissertation

  • Design of a 1.8-V 14-bit [delta] - [sigma] A/D converter with 8X oversampling and 4 MHz Nyquist output rate

    Creator:
    Jiang, Ruoxin
    Abstract:
    In this dissertation, a new Δ∑ A/D converter is presented that is ideally suited for communication applications. It is based on a single-loop single-stage structure, which can realize a high maximum out-of-band quantization noise gain while maintaining stable operation and thus achieve 14-bit resolution at 8 times oversampling. A fifth-order...
    Resource Type:
    Dissertation

  • Low voltage switched capacitor circuits for lowpass and bandpass [delta sigma] converters

    Creator:
    Keskin, Mustafa
    Abstract:
    The most accurate method for performing analog signal processing in MOS (metal-oxide-semiconductor) integrated circuits is through the use of switched-capacitor circuits. A switched-capacitor circuit operates as a discrete-time signal processor. These circuits have been used in a variety of applications, such as filters, gain stages, voltage-controlled oscillators, and modulators. A...
    Resource Type:
    Dissertation

  • Design techniques for low-voltage analog-to-digital converter

    Creator:
    Chang, Dong-Young
    Abstract:
    Continuous process scale-down and emerging markets for low-power/low-voltage mobile systems call for low-voltage analog integrated circuits. Switched-capacitor circuits are the building blocks for analog signal processing and will encounter severe overdrive problems when operating at low-voltage conditions. There are several well-known techniques to bypass the problem. These approaches include: (1)...
    Resource Type:
    Dissertation

  • High-performance delta-sigma analog-to-digital converters

    Creator:
    da Silva, Jose Barreiro
    Abstract:
    Multi-stage delta-sigma (ΔΣ) architectures, commonly known as MASH, are the preferred choice for analog-to-digital converters (ADCs) used in broadband communication applications, where high-resolution (above 14 bits) and high-bandwidth (several MHz) performances are required. Current state-of-the-art designs are capable of as much as 5-MS/s output data rates with 90-dB SNR. However,...
    Resource Type:
    Dissertation