This thesis is a development of two sets of equations predicting the switching times of a saturated transistor. The first set of equations defines the rise, storage, and fall times at a single operating point where the transistor beta, cutoff frequency and collector capacitance are known. The second set of...
This thesis describes the adder to be used with the Galaxy computer, which is to be constructed at Oregon State University.
The need for faster, more reliable adders is discussed
along with previous adder designs related to the
Galaxy Fast Carry Adder.
Both the logical design and circuit design of...
The operation of a tunnel-diode delay-line memory cell is
examined in some detail, and a digital computer program which
approximately simulates the operation of this memory cell is developed.
The data from the computer simulation is compared with the
available experimental data and found to agree very closely for clock...
This thesis
is concerned
with the
problems
which
need
consideration
when
designing
a
nanosecond
pulse
generator
having
a
repeatable
pulse
width
and
amplitude
output.
The
basic
circuit
is
first
presented
and
analyzed
and
the
reasons
for
wide
variations
in
pulse
width
with
replacement
of
transistors
are
pointed
out.
To
make...
This paper describes an inverter design which provides voltage
regulation against variations in both the input voltage and load impedance.
This design modifies the so-called parallel inverter, which
consists of two silicon controlled rectifiers (SCRs) operating in a
push-pull arrangement, to include a third regulating SCR. This
regulating SCR is...
The junction-field effect transistor has been improved technically,
so it is appropriate in analog switching applications. In this
paper, use of a junction FET as an analog switch is described.
Feedthrough of current from the gate control voltage causes a
noise at the output during the switching transient. Peak noise...
A short history is given of cathode-ray tubes, from the
earliest laboratory tubes available during the early 1900's through
present day high performance tubes. Special attention is paid to
the development of post-deflection acceleration types especially
band-type PDA tubes and an improvement on that type known as the
helix-type PDA...
This thesis is concerned with the design of a speech recognition
system to recognize digits 1, 2, 3 and 4. The system was designed
by using the characteristics of the spectral patterns of amplitude vs.
time at discrete frequencies. Data obtained for digits 0 to 9 are presented.
The outputs...
A set of circuit analysis programs designed for the IBM 1620
computer (having 40,000 digits of memory) is described and its operation
is explained. The set consists of d-c, a-c, and transient analysis
programs.
The d-c and a-c analysis programs provide the branch current
and node-to-reference potential for linear circuits....
In this paper the characteristics of multi-conductor transmission
lines have been investigated for a variety of termination conditions
by using the differential equations and matrix methods.
Equations showing the characteristics of traveling waves along loss-less
multi-conductor systems are derived.
Line parameters were evaluated by experiments and by calculations.
The results...
A circuit designed to generate and maintain a constant magnetic
flux is presented by using a sample-data control system, instead of a
continuous control system.
A Hall generator is used as the magnetic sensing element, and
is operated with a pulse bias to allow a large output. The output of...
The purpose of the thesis is to design, construct,
program, and test an automatic integrated circuit test
system. The class of integrated circuits tested was restricted
to digital integrated circuits. The general concept
of testing a digital integrated circuit is based on
the truth table of that circuit. A combination...
It is often necessary in communication systems to detect very
small signals that are buried in noise. One device used to accomplish
this is a lock-in amplifier. Initially the theory of operation is considered.
Then the circuit design of a low cost lock-in amplifier is
given. The amplifier, employing linear...
This thesis is concerned with the design of the high speed tape
read-out and tape feed control circuits and interface to the PDP-8/L
Computer system, The system was designed to operate under the
programmed data transfer mode of the computer, and is compatible
with the computer manufacturer's system.
The circuit...
A fluorescence anisotropy spectrophotometer known by
the acronym GUS has been in use at Oregon State University
in the department of biochemistry and biophysics for
several years under the supervision of Dr. Irvin Isenberg.
Dr. Isenberg wished to improve the accuracy, versatility,
speed of data acquisition, and ease of operation...
This thesis is concerned with the design of the interface--Read,
Write and control circuits--of the magnetic disc with the PDP-8/L
Computer system. The interface was designed to operate under the
Data Break transfer mode of the computer and is compatible with the
computer manufacturer's system.
The Data Break option was...
CP1100/GPIB Interface is an interface between the "General
Purpose Interface Bus", which is an implementation of the Universal
Bus described in IEEE Standard 488-1975, and Unibus. This interface
enables TEKTRONIX CP1100 series controllers to operate
GPIB- compatible instruments connected to the General Purpose
Interface Bus. The designer can now incorporate...
Recent acheivements in high speed digital integrated
circuits has prompted the system designers to search for
a practical method of inter-connecting these high speed
circuits. This paper describes the implementation of the
microstrip transmission line on a high speed digital
data bus. Transmission line and characteristic impedance,
termination with single...
This paper is concerned with the application of
hierarchial and parallel computing structures to digital
data communications processing in a multi-access telecommunications
environment. Designs are analyzed and
evaluated in terms of data collected from remote access
tele-communications traffic and in terms of the application
to several processing problems in the...
The high cost of content-addressed memories (CAM) can be reduced
significantly by using a circulating memory system. With the
circulating system, comparison logic is shared by many memory locations
to allow a reduction in cost.
Three data organizations are described and evaluated and one
is chosen as the best for...
One of the most promising methods of constructing bandpass
filters without inductors is the RC digital filter. It is simply a number
of parallel RC branches which are sequentially switched between
the source and the load. If the source signal is at the same frequency
as the switching rate of...
The purpose of this study was to provide information
pertaining to performance levels of Dvorak keyboard operators
through retraining. More specifically, the purposes of
this study were:
1. To compare operator performance rates on the
Dvorak keyboard with operator performance
rates on the Qwerty keyboard.
2. To determine whether keyboard...
The purpose of this study was to supply information
that would help improve typing courses by identifying
successful skillbuilding practices and to provide students
with a means of increasing speed and/or accuracy during
timed writings. More specifically, the purpose of this
study was to answer the question:
Does the previewing...
Engineering students spend a significant amount of their undergraduate careers focused on technical theory and practice. This intensive student prepares them for their technical challenges in the future. This training is so intense that often the more 'soft skills' such as communication, leadership, design, and troubleshooting are left out or...