Performance evaluation of conventionally reinforced concrete (CRC) bridge superstructure elements with diagonal cracks is of interest to the bridge engineering community. Standardized methods to predict service-level stress magnitudes in cracked bridge girders under combined bending and shear forces are not available. An analysis procedure was developed to determine the response...
Corrosion of embedded carbon steel is a leading factor in deterioration of aging conventional reinforced concrete structures. Methods to accurately predict remaining capacity of corrosion damaged elements, especially shear capacity, are lacking. In this paper, ACI-AASHTO approach, Strut and Tie Method, Modified Compression Field Theory, and Response 2000 were used...
The migration of chloride ions in concrete with steel reinforcement under cathodic protection was investigated. Mortar blocks (15 cm x 15 cm x 17 cm) of various composition (water to cement ratio, chloride ion content) were cast with an iron mesh cathode embedded along one face and a thermally sprayed...
Structurally efficient and cost-effective solutions are needed to extend the service-life of deficient and aging highway infrastructure around the world. One critical need is to increase the flexural strength of older reinforced concrete (RC) structures to carry heavier and more frequent loads. Titanium alloy bars (TiAB) offer a new opportunity...
Corrosion of reinforcement is recognized as the predominant factor that limits the service life of reinforced concrete (RC) structures exposed to aggressive environments. This corrosion deterioration can lead to damage resulting in capacity loss or even failure. For structures exposed to coastal marine environments or deicing or anti-icing applications, this...
Carbon fiber reinforced polymer (CFRP) materials are emerging as an effective means of strengthening and rehabilitating bridges. Near surface mounting (NSM) is a newer technique for application of CFRP for retrofitting of bridge members that provides advantages over conventional strengthening techniques. The technique is still new and uncertainties remain regarding...
A need exists to develop a non-destructive testing technique that can identify
the formation and propagation of diagonal tension cracks in conventionally
steel reinforced concrete deck girder (RCDG) highway bridges in the State of
Oregon. Such a technique could be included into a structural health
monitoring (SHM) system installed on...
A numerical model for the cathodic protection of steel in reinforced concrete is developed. Parameters are set to represent a three-dimensional section of a bridge beam exposed to the atmosphere and coated with a thermally sprayed zinc anode. Both diffusion of oxygen and conduction of charge within the concrete are...
Steel corrosion in reinforced concrete is a major concern to transportation agencies nationwide because of the expenses incurred for repair and ultimate shortening of bridge life. Cathodic protection (CP), as a remedy, has been applied to reinforced bridges in the US since 1974. However, application of this technique is largely...
In this thesis, the effectiveness of the 100 percent + XX percent seismic response directional combination rule available in codes and standards is evaluated using simulated nonlinear seismic response of two existing multi-story reinforced concrete plan-irregular buildings. The 5-story and 8-story buildings were designed according to the 1975 seismic codes...