"There are at present four common methods of con
verting the alternating current into direct current.
These are in order of use, the motor generator set,
the rotary converter, mercury vapor rectifier and the
Murphy rectifier. A short description of these and
connections for the last two will be given."--p.2
In advanced hybrid electric vehicle development, performance and dependability are essential considerations in the design process. High efficiency is crucial in a successful design and fault tolerance is necessary to provide limp-home capability under faulted operating conditions. The reduction of electromagnetic interference is mandatory to reduce interference in communications and...
This paper describes an inverter design which provides voltage
regulation against variations in both the input voltage and load impedance.
This design modifies the so-called parallel inverter, which
consists of two silicon controlled rectifiers (SCRs) operating in a
push-pull arrangement, to include a third regulating SCR. This
regulating SCR is...
The loads on the electrical systems of automobiles are projected
to increase significantly in the near future. This will result in a
requirement for improved efficiency over the present-day car
alternators. An alternative scheme proposed at Oregon State
University employs a Brushless Doubly-Fed Machine (BDFM) as an
alternator.
This thesis...
The prevalence of Internet-of-Things (IoT) applications leads to an increasing focus on the design and optimization of sensor nodes. Battery lifetime and associated costs of battery replacement often limits the long term operation and viability of sensor nodes. RF wireless energy harvesting on the other hand can be appealing since...
Harvesting energy from the environment for powering micro-power devices have been increasing in popularity. These types of devices can be used in embedded applications or in sensor networks where battery replacement is impractical. In this dissertation, different methods of energy harvesting from the environment are explored as alternative sources of...
Advanced low power devices promote the development of micro power generators (MPGs) to replace the batteries to power them. Due to the trend in decreasing integrated circuit (IC) supply voltages, power supply designers are facing more and more serious challenges. The objective of this research is to design a power...
Wave energy conversion devices are a rapidly growing interest worldwide for the potential to harness a sustainable and renewable energy source. Due to the oscillatory nature of ocean waves, the power generated from a permanent magnet linear generator (PMLG) for ocean wave energy conversion is pulsed. Focusing on direct drive...
The awareness of electric power quality has increased over the past decade as electronic equipment
has become more susceptible to power disturbances. The most disruptive power disturbances are voltage
sags and momentary interruptions and their effect on adjustable speed drives (ASDs) is studied in this
thesis.
Several solutions have been...