The Arctic climate system is changing dramatically as a response to rising atmospheric greenhouse gas concentrations. Key indicators of Arctic change include thinning and retreating of Arctic pack ice, thawing permafrost, greening tundra, and rising surface temperatures. The structure of the atmospheric boundary layer influences and is influenced by processes...
Autonomous buoys were deployed in 2011 in the central Arctic: An Ice-Tethered Profiler (ITP) and Ice Mass Balance (IMB) buoys were deployed in the Makarov basin; a Polar Ocean Profiling System (POPS) and Ice Thickness (Ice-T) buoy were deployed on the Eurasian Basin. The two different sites were approximately 70km...
In winter and spring, ice-coast interactions driven by winds and ocean currents cause sea ice fractures (leads) to form repeatedly along Arctic coastlines. These events are often associated with rapid and expansive changes in sea ice drift and state that are challenging to predict and represent in models. We investigate...
Leads are long fractures wide enough for a ship to travel through the ice pack. Sea ice acts as a barrier between the ocean and the atmosphere, whereas leads allow the transfer of heat and moisture between the two. Leads play a role for marine mammals and are hunting grounds...
During summer 2007, perennial sea ice in the Beaufort Sea, Arctic Ocean, experienced an unprecedented amount of basal melt. It has previously been shown that this basal melt was linked to an increase in open-water fraction, increasing absorption of solar radiation into the ocean. GPS ice drifters, deployed around the...
The low-level baroclinic eddy activity seen in the NASA Ames Mars General Circulation Model (MGCM) for simulations under three annual dust cycles are characterized. Simulations were conducted with both radiatively active and radiatively inert clouds (RAC and non-RAC, respectively) for 11 continuous annual cycles for each dust case. Model results...
Methods were developed for the co-encapsulation of slow release compounds (SRC) with viable microbial cells in alginate and gellan gum hydrogel beads, for the in-situ aerobic cometabolic treatment of groundwater contaminated with mixtures of 1,4-dioxane and chlorinated aliphatic hydrocarbons, which will be referred to as contaminants of concern (CoC). The...
The evolution of the near-inertial internal wavefield from ice-free summertime conditions to ice-covered wintertime conditions is examined using data from a yearlong deployment of six moorings on the Beaufort continental slope from August 2008 to August 2009. When ice is absent, from July to October, energy is efficiently transferred from...
Sintering of nanoparticles to create films and patterns of functional materials is emerging as a key manufacturing process in applications like flexible electronics, solar cells and thin-film devices. Further, there is the emerging potential to use nanoparticle sintering to perform additive manufacturing as well. While the effect of nanoparticle size...
Timber-concrete composite (TCC) solutions originated in the early twentieth century. There has been a renewed interest in TCC solutions in modern mass timber buildings, especially for floor systems. However due to lack of data, design standards, and code acceptance, TCC solutions require that new mass timber solutions be tested, and...