Measurement of the copper to superconductor ratio (Cu/SC) in
composite superconducting wires is necessary for process control, quality
assurance, and characterization of the final wire properties.
A comparison has been made of three techniques for measuring the
Cu/SC ratio on a set of commercial wires produced for the Superconducting
SuperCollider...
Elastic properties of plywood panels are essential for predicting
structural behavior of wood systems. The ASTM Standard D 3043-76
which evaluates the moduli of elasticity (MOE) of plywood, treats
these panels as one dimensional beams instead of two-dimensional
plates, which results in an overestimate of the MOE. Improved procedures
for...
The application of laser generated ultrasonics was first
demonstrated in the mid-seventies and has shown good potential
when applied to isotropic materials. However, its use with
composite materials is still in the early stages of development.
This study explores the potential for application of laser
generated Rayleigh and Lamb waves...
This dissertation investigates by means of computer simulation the potential of a
Band Variable-Inertia Flywheel (BVIF) to store energy for an urban transit bus.
Replacing both a fixed-inertia flywheel (FIF) and a continuously variable transmission
(CVT), the Band Variable-Inertia Flywheel is capable of accelerating a vehicle
from rest to a...
The focus of this study is the effective prioritization of customer requirements in collaborative product development. The CR priorities are often retrieved by questioning and interviewing targeted customers. But the targeted customer might not always be easily questioned, because they might not always be obvious or clearly known. If customers...
Polymeric composites reinforced with bio-materials have advantages over composites with synthetic reinforcements. Bio-based composites use low-cost and renewable reinforcements, have nonabrasive properties for machining, have improved damping characteristics, and have potential for energy recycling. However, the limited use of bio-based composites is because their mechanical properties are typically much lower...
With growing concerns on environment impact of industrial product development, the product developers are seeking better solutions to achieve desired environmental benign requirements by the regulators and customers besides economic growth. During the last decade, some of the most successful product development companies (such as HP) have established their own...
A significant barrier to the diffusion bonding of large (i.e. 600 mm) microchannel devices is the large capital investment required to setup production. This large capital investment extends from long heating and cooling cycles leading to poor production
capacities. Empirical studies in industry have shown that cooling rate is limited...