The stress concentration factors at butt joints in six-ply laminated
lumber were determined experimentally. Concentration factors
for a uniform tensile stress were found for a joint at each of
three possible locations.
Four experimental techniques were used and evaluated on actual
wood specimens: strain gages, brittle lacquer, moiré grids, and...
A study of stress transfer near the ends of the whisker in a simulated whisker reinforced composite material was conducted by using
photoelastic techniques. The composite material studied was
αAl₂O₃ whiskers in an aluminum matrix. The photoelastic models
used consisted of a scaled-up macroscopic stiffener embedded in a
three-dimensional epoxy...
The determination of failure is complicated when a structural
element is subjected to combined rather than simple stresses. This
is especially true when the principle of superposition does not apply.
For such cases, tests of the element under the expected loads are
required to determine its failure criteria.
In this...
The concept of a prestressed cylindrical shell was investigated. In particular, a cylindrical shell constructed from coiled pressurized tubing was analyzed. This analysis was concentrated in two main areas, the first involved the failure modes of the prestressed cylinder. Both the buckling and yielding behavior of the tube walls was...
A numerical technique is presented for solving the gas dynamics
of a pulsating combustor. The computer solution which is developed
follows directly from the fundamental conservation laws applied to
discrete volumes rather than attempting either to finite difference the
resulting partial differential equations, or to apply the Method of Characteristics....
The merits of the photoelastic coating technique as applied to
wood were evaluated. Comparative tests were made on 12 nominal
two-by-four Douglas Fir boards. The object of these tests was to
determine the limitations of this technique, such as accuracy and
complexity of experimental procedure. Correlation of the experimental
results...