This research examined the potential for using peanut husk as a fiber alternative to wood in the production of melamine-formaldehyde (MF) particleboard. MF resin was used to produce panels with one, three, six, nine or 12 percent resin contents. Modulus of Rupture (MOR), Modulus of Elasticity (MOE), Internal Bond (IB)...
Chainsaw users value cutting performance and safety. Knowledge of the forces exerted during sawing are necessary to understand and improve the cutting performance of saw chain. Additionally, cutting forces can be used to form metrics for evaluating performance tradeoffs when using a safety (i.e. low-kickback) saw chain versus a standard...
:
__________________________________________________________________
John P. Parmigiani
Chainsaw users value cutting performance and safety. Knowledge of
Restoration programs effectively prevent or mitigate wildfires and pest outbreaks in the forest lands. The most common approach is to selectively harvest smaller and dead trees in order to preserve larger and superior trees. Ponderosa pine, Pinus ponderosa, (PP) lumber is one of the common species harvested from restoration programs...
Timber-concrete composite (TCC) solutions originated in the early twentieth century. There has been a renewed interest in TCC solutions in modern mass timber buildings, especially for floor systems. However due to lack of data, design standards, and code acceptance, TCC solutions require that new mass timber solutions be tested, and...
Cross-Laminated Timber (CLT) is a prefabricated building material that is relatively new to the United States and North America. It consists of no less than three layers of graded, dimensional lumber glued in alternating longitudinal and transverse layers to create a panel that can be used for various building applications...
Chainsaws, an indispensable tool for modern forestry operations, rely on bar lubricant to prevent rapid wear of the chain and bar. Choice of bar lubricant must balance performance, cost, and biological impact. Many bar lubricants are available, but little published work exists that conclusively ranks the performance of these choices....
This study computationally and experimentally examines the mechanisms of crack penetration, deflection and the transition between penetration and deflection. The finite element analysis based computational modeling work used strength-and-energy based cohesive-zone approach to study the effect of dimensionless parameters (e.g., interfacial incident angle, fracture-length scale, and normalized toughness) on penetration/deflection...
Most of existing commercial unsaturated polyester (UPE) resins are typically composed of a UPE and a high amount of highly volatile, flammable, and toxic styrene. The emission of hazardous styrene in the handling of the UPE resins and the preparation and use of fiber-reinforced UPE composites poses severe hazards to...
Existing pressure sensitive adhesives (PSAs) are mostly based on petrochemicals. In this study, a novel PSA based on a renewable material, methyl oleate, was prepared and characterized. Methyl oleate was first epoxidized to form epoxidized methyl oleate that was subsequently hydrolyzed and acidified to form epoxidized oleic acid (EOA) which...
Cellulose nanocrystals (CNCs) have received considerable attention over the last ten years because CNCs can be produced from renewable materials such as straw, wood, cotton, and sea animals (tunicates). CNCs are slender rods with high aspect ratios (10-100) and the final dimensions of the CNCs depend on the starting material....