Renewable electrical energy sources are relatively easy to integrate at moderate penetrations, utilizing a combination of technical and market methods to increase grid flexibility. However, integrating high renewable portfolios is more challenging, and the optimal combination of resources will vary depending on the features of specific geographic areas. This study...
Indoor localization systems have a variety of applications such as tracking of assets, indoor robot navigation, and monitoring of people (e.g. patients) in hospitals or at home. Global positioning system (GPS) offers location accuracy of several meters and is mainly used for outdoor location-based applications as its accuracy degrades significantly...
The ability to accurately locate people and objects indoors will enable opportunities for control and automation of indoor environments. Current indoor localization solutions require dedicated hardware which must be custom tailored to each application. There are large technological, societal, and economic benefits in developing a more general purpose system that...
Low-power receivers (RX) with 100$\mu W$-scale power consumption can enable several power/energy-constrained IoT applications. However, achieving sensitivity, interferer tolerance and wide operating range with low power presents a challenge for existing architectures, particularly those constrained to highly integrated solutions without high-Q off-chip components. Existing solutions rely heavily on high quality...
The objective of the work reported herein is to explore the impact of decreasing channel thickness on radio-frequency (RF) sputtered amorphous indium-gallium-zinc oxide (a-IGZO) thin-film transistors (TFTs) electrical performance through the evaluation of drain current versus gate voltage (I[subscript D] − V[subscript G]) transfer curves. For a fixed set of...
Retention of engineering students is a problem for many universities, especially during the first year. The problem of introducing students to engineering while increasing retention rates has recently been addressed by many different universities. Implementing novel lab structures, adjusting the lecture to incorporate more effective teaching techniques, and using orientation...
The electrical stability of amorphous indium-gallium-zinc oxide (a-IGZO) thinfilmtransistors (TFTs) is investigated for flat-panel display applications. Althoughproducts incorporating a-IGZO TFT backplanes are already commercially available,e.g., iMac with 5K retina display, technical challenges need to be addressed for nextgenerationapplications, e.g., active-matrix organic light-emitting diode displays.Device stability is one crucial issue. The...
The thesis focuses on the development of a novel printed resistive humidity sensor and integrated flexible electronics for an RFID-enabled humidity sensing platform. We explored a hybrid nanocomposite material for humidity sensing consisting of carbon nanomaterials, conductive polymer and cellulose polymer that undergoes resistance change in response to humidity change....
In the next decade, technology trends--smaller dimension, lower voltage, higher operating frequency--introduce new technical considerations and challenges for radiation effects in integrated circuits. Semiconductor based circuits and traditional dynamic random-access memories will malfunction when exposed to extreme environments, such as space and nuclear reactor. The mechanisms for radiation effect are...
In recent years, there has been growing interest in both industry and academia to use continuous-time (CT) Δ-Σ A/D converters for wideband wireless and wireline communication applications.
So far no reported CT Δ-Σ A/D modulator achieves 14-bit or higher dynamic range (DR) with more than 2MHz signal bandwidth (equivalently 4MS/s)....
Digitally controlled switching DC-DC converters have recently emerged as an attractive alternative to conventional switching converters based on analog control techniques. This research focuses on eliminating the issues associated with the state of the art switching converters by proposing three novel control techniques: (1) a digitally controlled Buck-Boost converter uses...
MANETs are known to be useful in situations where mobile nodes need to communicate and coordinate in dynamic environments with no access to fixed network infrastructure. However, connectivity problems can occur when sub-groups within a MANET move out of communication range from one another. The increasingly prolific use of UAVs...
The aim of this dissertation is to develop oxide semiconductors by radio-frequency
sputtering for thin-film transistor (TFT) applications. A variety of oxide semiconductors
are used as the TFT channel layer, including indium gallium oxide (IGO), zinc tin
oxide (ZTO), and indium gallium zinc oxide (IGZO). The variety of materials used...
A fully integrated CMOS GPS receiver RF front end optimized for low power operation is presented. The system operates with a supply voltage down to 250 mV. A prototype has been fabricated in a 0.13μm CMOS process and includes a low voltage LNA, quadrature oscillators, and quadrature mixers. It exhibits...
The focus of this thesis is the investigation of thin-film transistors (TFTs) based on amorphous oxide semiconductors (AOSs) in two circuit applications. To date, circuits implemented with AOS-based TFTs have been primarily enhancement-enhancement inverters, ring oscillators based on these inverters operating at peak frequencies up to ~400 kHz, and two-transistor...
Multi-instance data, in which each object (e.g., a document) is a collection of instances
(e.g., word), are widespread in machine learning, signal processing, computer vision,
bioinformatic, music, and social sciences. Existing probabilistic models, e.g., latent
Dirichlet allocation (LDA), probabilistic latent semantic indexing (pLSI), and discrete
component analysis (DCA), have been...
Data converters are essential interface circuits between the analog world that people live in and the digital processors that people live with. Linearity, which often is a tradeoff against other performance criteria, is one of the major performance demands from applications for both analog-to-digital converts (ADC) and digital-to-analog converters (DAC)....
Back end of line (BEOL) metal-insulator-metal capacitors (MIMCAPs) have become a core passive component in modern integrated circuits. International Technology Roadmap for Semiconductors (ITRS) projections for scaling of analog/mixed-signal MIMCAP applications require simultaneously increasing capacitance density while maintaining low leakage current density and low voltage nonlinearity (characterized by the quadratic...
The CMOS two-stage Operational Transconductance Amplifier (OTA) has been a key enabler for mixed-signal IC design for nearly four decades . This research focuses on a modified two-stage CMOS OTA that features load-pole cancellation (LPC); i.e., the resulting architecture is essentially a two-stage CMOS OTA with no load capacitance. The...
Power and timing requirements are becoming more and more stringent as applications move from less mobile devices to more mobile ones. As such, it is important to optimize these applications as much as possible in order to provide the best solution that is low power and low latency. Although there...