Computers
are
very
efficient
in
handling
the
problems
which
deal
with
iteration.
Numerical
treatment
of
the
unsteady
energy equation
is
one
sort
of
iteration.
The
convergence
of
the
unsteady
film
coefficient,
in
two
dimensional
space,
to
its
steady
state
value
has
been
deduced
by
comparison
of
the
results
of
the...
The general theory of characteristics is reviewed for hyperbolic
partial differential equations of n independent variables. The
application of the theory of characteristics is made to unsteady, two-dimensional, rotational, inviscid flows; unsteady, two-dimensional,
irrotational, inviscid flows; and unsteady, axial symmetric, inviscid
flows. The characteristic surfaces and the compatibility relations
are...
The respiratory tract is lined with a mucous blanket which is
motivated by a ciliated epithelium. This blanket includes a lower
serous layer of fluid through which the cilia beat and an upper viscid
layer into which particulates from the inhaled air are deposited.
The movement of the mucous blanket...
The base Al-Zn superplastic alloy was investigated at 250°C to
determine the effect of small amounts of magnesium on mechanical
properties. Six alloys of nominal composition 0.00, 0.10, 0.25,
0.50, 0.75, and 1.00 weight percent magnesium, constant 78 weight
percent zinc, and variable 21 to 22 weight percent aluminum were...
The zirconium-chromium phase diagram was investigated in the
region between 40% and 85% chromium. The ZrCr₂ intermetallic
compound which has been the source of some controversy was especially
considered. It was found that ZrCr₂ transforms from the low
temperature C-15 (MgCu₂, FCC) structure to the high temperature
C-14 (MgZn₂, HCP)...
Flat, laminar, premixed hydrocarbon-air flames were stabilized
on a porous-plate burner. In addition to temperature profiles,
concentration profiles were measured for methane, ethane, ethylene,
propane, acetylene, propylene, carbon monoxide, carbon dioxide and
oxides of nitrogen. Dead space thickness, luminous flame zone
thickness and hydrocarbon disappearance point responses were also
monitored....
The noise problem in air conditioning systems is receiving ever
increasing attention because of the importance of noise on a comfortable
human environment. Some work has been done on the solutions
to the noise problem by an investigation of a few system elements.
The acourstical characteristics of dampers become more...
The repetitious nature of air conditioning calculation leads to
arithmetic errors and a high cost of designing air conditioning systems.
Short cut calculations are employed to limit the calculation
and the chance of making errors.
Computers with their high speed of calculation and the ability
to make limited "logic's decisions...
The free convective heat transfer phenomena in air between two
vertical plates 24 by 38 inches spaced 15.895 mm apart, was investigated in this experimental study. One plate was isothermal and, the
other adiabatic.
A quartz fiber anomometer was used for measuring local
velocities in the air between the vertical...
A source test was conducted to determine the particulate and the
total gaseous hydrocarbon emissions from a gas heated veneer dryer.
Samples were taken on eight separate days from the exhaust stacks
while the dryer was processing Douglas fir veneer. Of the eight days,
three was used to determine the...
The study of aldehydes in diesel exhaust is important because
of their relationship to diesel odor, to air pollution, and to the development
of a theory of combustion. Therefore, a study is made
of the low order aliphatic aldehydes using gas chromatography in
conjunction with standard wet chemical tests.
The...
Solid solution alloying was employed in an attempt to produce some
relatively ductile form of beryllium. If the c/a ratio could be significantly
altered, it was felt new or different slip systems could be activated. The
following elements were selected on the basis of atomic size, melting point,
crystal structure...
Radiation induced heat generation rates of several nonfissionable materials were measured calorimetrically in a nuclear reactor environment. The calorimeter was uniquely designed to allow many materials of grossly different heat generation rates to be measured. heat transfer characteristics of the calorimeter were determined analytically and experimentally. Materials were chosen to...
Southern pine and Douglas fir veneer samples were dried in air
under the following conditions: air temperatures were 350, 600, and
750°F; air velocities were 50, 100, and 150 feet per second, and
angles of impingement of air against the veneer surfaces were 0°,
45°, and 90°. The resulting drying...
The removal of ozone from an air stream by activated-cocoanut
charcoal was investigated from the literature and experimentally.
The experimental investigation showed that activated-cocoanut charcoal
can be used to remove concentrations of ozone less than 1.0
ppm with high efficiencies. The mechanism of the ozone removal
appeared to be a...
An integrating nephelometer was set up at the Eugene Airport
which is located five miles north of Eugene, Oregon, on Highway
99 West. Continuous atmospheric scattering coefficient readings
were obtained from July 1, 1969, to August 28, 1969. These data
are converted to meteorological range through the use of the...