Search Constraints

Start Over
Filtering by: Creator Gale, N. H. Remove constraint Creator: Gale, N. H. Advisor Mayaram, Kartikeya Remove constraint Advisor: Mayaram, Kartikeya Committee Member Liu, Huaping Remove constraint Committee Member: Liu, Huaping

Search Results

  • An enhanced swing differential Colpitts CMOS VCO for low-voltage operation

    Creator:
    Farahbakhshian, Farhad
    Abstract:
    An enhanced swing differential Colpitts VCO (ESDC-VCO) dramatically improves the swing of a Colpitts VCO by allowing the signal to swing below ground and above the supply voltage. Fabricated in a 1P8M 0.13 um CMOS process, the ESDC-VCO operates at 4.9GHz with a 0.475-V supply and consumes 2.7mW. The measured...
    Resource Type:
    Masters Thesis
    Full Text:
    10 7 −150 −145 −140 −135 −130 −125 −120 −115 −110 −105 −100 Frequency (Hz) P h as e N

  • Ultra-low power receivers for wireless sensor networks

    Creator:
    Ayers, James S.
    Abstract:
    In wireless sensor network applications, low-power operation of the wireless receiver is critical. To address this need an ultra-low power Binary Frequency Shift Keying (BFSK) receiver using the super-regenerative architecture is developed. A prototype receiver is built and tested for operation in the 900 MHz ISM band. Lab measurements show...
    Resource Type:
    Dissertation
    Full Text:
    before 9 being demodulated. The total gain of a system with N cascaded gain stages is given by A

  • Layout dependent and bias independent scalable substrate model for RF MOSFETs

    Creator:
    Suravarapu, Ravikanth
    Abstract:
    The dependence of the substrate resistance, R[subscript sub], for MOS transistor RF modeling on transistor biasing and layout is studied from device simulations and measurements. Though R[subscript sub] is found to be bias dependent, the error incurred by assuming a constant value equal to the DC resistance is not significant....
    Resource Type:
    Masters Thesis
    Full Text:
    APPENDIX A. Procedure for Obtaining the Equations Describing Rb as a Function of n for a Given d

  • Modeling and simulation methods for RF MEMS VCOs

    Creator:
    Sankaranarayanan, Janakiram Ganesh
    Abstract:
    This work focusses on the modeling and the development of efficient coupled simulation techniques for MEMS based RF oscillators. High-level models for MEMS based varactors have been discussed and their accuracy issues are identified, based on comparisons with numerical simulations. A faster simulation approach based on the time-domain shooting method...
    Resource Type:
    Masters Thesis
    Full Text:
    ) = 1/m s2 + ωn QM s + k m (2.5) 8 Spring Damper d1 (initial separation) x V FIGURE 2.2. Mass

  • Noise and Blocker Cancellation Techniques for Power and Area Efficient Wireless Receivers

    Creator:
    Pourbagheri, Saeed
    Abstract:
    The design of mobile wireless devices has always focused on reducing power, area, and cost. This dissertation proposes two techniques that are leveraged to save power and area and therefore cost. The first techniques reduces the noise in the receiver and results in a relaxed power requirement. The second technique...
    Resource Type:
    Dissertation
    Full Text:
    ) conventional architecture, and (b) proposed architecture. ()dt bit + - Vref s,n Balun ()dt bit s,n1 s

  • Comparison and impact of substrate noise due to clocked and clockless circuitry

    Creator:
    Le, Jim K.
    Abstract:
    Delay insensitive asynchronous circuitry provides significant advantages with respect to substrate noise due to localized switching. The differences between the substrate noise from NULL Convention Logic (NCL) and traditional Clocked Boolean Logic (CBL) are described and analyzed based on measured results. A test chip fabricated in the TSMC 0.25 um...
    Resource Type:
    Masters Thesis
    Full Text:
    coupling is heavily dependent on the time derivative of 2 Time N u m b er o f T ra n si ti o n

  • An ultra low voltage micropower GPS receiver RF front-end for wildlife tracking

    Creator:
    Heiberg, Adam C.
    Abstract:
    A fully integrated CMOS GPS receiver RF front end optimized for low power operation is presented. The system operates with a supply voltage down to 250 mV. A prototype has been fabricated in a 0.13μm CMOS process and includes a low voltage LNA, quadrature oscillators, and quadrature mixers. It exhibits...
    Resource Type:
    Masters Thesis