Ring amplification has emerged as an efficient technique to drive large capacitive loads in switched capacitor circuits. We propose circuit techniques to demonstrate the first application of a ring amplifier in a non-capacitive feedback system of a LDO. These techniques enable a simple cap-less LDO structure in 180nm CMOS that...
This thesis proposes a novel technique for the design of pipelined and cyclic ADCs utilizing generalized radix gain stages. Several models have been proposed for the optimization of high performance pipelined ADCs by various researchers. This work builds upon them, using a simple but accurate model to estimate the optimal...
To realize pipelined ADCs in deep-submicron processes, low voltage techniques
must be developed to work around problems created by limited supply voltages such as
the floating switch dead zone, reduced SNR, and reduced OpAmp performance.
This thesis analyzes standard and low voltage design issues for pipelined ADCs
and proposes a...
In recent years, SAR ADCs have been shown to acheive faster conversion times and improved power efficiencies due to their simple building blocks that are digital in nature and scale favorably with technology. High resolution ADCs with stringent noise requirement has led to the adoption of hybrid ADC architectures such...
Pipeline analog-to-digital converters (ADCs) have long been used in high-speed systems for power-efficient data conversion. Broadband communication and video processing systems are placing high demands on converter accuracy and speed (above 14 bits and in the multiple-MHz range). The increasing converter requirements coupled with lower supply voltages in modern processes...
Multi-stage delta-sigma (ΔΣ) architectures, commonly known as MASH, are the preferred choice for analog-to-digital converters (ADCs) used in broadband communication applications, where high-resolution (above 14 bits) and high-bandwidth (several MHz) performances are required. Current state-of-the-art designs are capable of as much as 5-MS/s output data rates with 90-dB SNR. However,...
Data converters are ubiquitous building blocks of a signal chain. The rapid increase in
communication and connectivity devices presents new avenues for pushing the state of
the art analog to digital converters. Techniques for improving resolution, bandwidth,
linearity and bit-error rate, while reducing the power, energy and area is the...
The design of mixed-signal integrated circuits has evolved from simple analog and digital circuits operating on the same silicon substrate to the point that now we have complete system on a chip solutions for communication systems. The levels of integration needed to remain cost effective in today's integrated circuit (IC)...
Evolution of the mobile communication standards and proliferation of hand-held devices mandate stringent Analog-to-Digital Converter (ADC) specifications. Among various ADCs, a ∆Σ ADC is best known as a power-efficient ADC when more than 12b is required. However, a conventional discrete-time (DT) ∆Σ Modulator (∆ΣM) is inadequate for low-power wideband applications...
With the ever-increasing demand for portable devices used in applications
such as wireless communication, mobile computing, consumer electronics, etc.,
the scaling of the CMOS process to deep submicron dimensions becomes more
important to achieve low-cost, low-power and high-performance digital systems.
However, this downscaling also requires similar shrinking of the supply...
Ring Amplifier serves as a great candidate both for precision amplification and fast integration in the discrete time system. It can be utilized in high-performance analog-to-digital converters (ADCs). In high-speed ADC utilizing pipelined architectures with residue amplification, Successive-Approximation Register (SAR) ADCs as the sub-ADC and power efficient Ring Amplifier based...
As the CMOS process scales down to submicron, digital circuit performance improves, while reduced supply voltage and lower transistor intrinsic gain make it difficult to implement analog circuits in a power efficient manner. Therefore, it has become advantageous to shift more analog signal processing functions conventionally realized in voltage (analog)...
In this work a new voltage buffer, the drain-follower, achieves 300MHz band-width with 2pF load, a dc gain of 0.993V/V, 1mV offset voltage, -60 dB total harmonic distortion at 1.4Vpp output voltage and 6.5mW power dissipation from 5V supply. A unity-gain buffer switched-capacitor biquad filter has been implemented in 0.5μm...
The objective of this work is to explore the feasibility of replacing conventional op-amps with inverters in switched-capacitor (SC) circuits. In order to verify the idea, a low-pass filter (LPF) and a second-order delta-sigma (∆Σ) analog-todigital converter (ADC) are designed in the 0.5-m CMOS technology. The low-pass filter structure is...
This thesis presents a novel algorithmic A/D converter to be used in a biosensor. The converter is capable of a conversion rate of 1.5 bits/phase and hence the required conversion time is reduced. The proposed architecture is analyzed for non-ideal effects and compared with existing algorithmic A/D architectures. The converter...
Recently, switched capacitor DC/DC converters are extensively used in portable electronic devices because they feature many advantages, such as high efficiency, small package, low quiescent current, minimal external components and low cost. In this thesis, two step-down switched capacitor DC/DC converters are designed. One has the fixed output options 1.5V,...
The demand for portable electronic systems and the continued
down-scaling of device dimensions resulted in rapid improvement in
the performance of integrated systems. Several low-voltage design
techniques have been proposed to operate analog circuits with sub-1V
supply. However, these techniques require higher power consumption
to achieve large dynamic range while...
Continuous process scale-down and emerging markets for low-power/low-voltage mobile systems call for low-voltage analog integrated circuits. Switched-capacitor (SC) circuits are the building blocks for analog signal processing and will encounter severe overdrive problems when operating at low voltage conditions. There exist three techniques to solve the problem, but with their...
A radix-based calibration technique was previously proposed with a two-stage algorithmic analog-to-digital converter (ADC). The objective of this work is to verify the capability of radix-based calibration for a true multi-stage ADC. In order to prove the idea, a single bit-per-stage, 20-stage pipelined ADC is designed in a 0.35-μm CMOS...
Digital phase-locked loops (PLLs) have been receiving increasing attention recently due to their ease of integration, scalability and performance comparable to their analog counterparts. In digital PLLs, increased resolution in time-to-digital conversion is desirable for improved noise performance. This work describes the design and simulation of a stochastic time-to-digital converter...
Spacecrafts experience radiation in the course of their operation
and all electronic equipment on board these spacecrafts has to
be designed to withstand the effects of this radiation.
This thesis describes the effects of total ionization dose (TID)
and single event transients (SET) in phase-locked loops - an
important circuit...
As advanced wired and wireless communication systems attempt to achieve higher performance, the demand for high resolution and wide signal bandwidth in their associated ADCs is strongly increased. Recently, time-domain quantization has drawn attention from its scalability in deep submicron CMOS processes. Furthermore, there are several interesting aspects of time-domain...
Continuous process scale-down and emerging markets for low-power/low-voltage mobile systems call for low-voltage analog integrated circuits. Switched-capacitor circuits are the building blocks for analog signal processing and will encounter severe overdrive problems when operating at low-voltage conditions. There are several well-known techniques to bypass the problem. These approaches include: (1)...
This thesis presents a continuous time bandpass delta sigma modulator with frequency translation inside the delta sigma loop. The input IF signal is down converted to baseband after amplification by a low Q, wideband bandpass resonator. The down converted IF signal is digitized by a continuous time, second order lowpass...
This thesis proposes a novel fully digital technique for the estimation and correction of the DAC error in multi-bit delta sigma ADCs. The structure of the DAC error is indicated through a simple model for unit-element based DACs. The impact of the DAC error on the performance of ADC is...
Switched-capacitor (SC) circuits are commonly used for analog signal processing because they can be used to realize precision filters and data converters on an integrated circuit (IC). However, for high speed applications SC circuit operating speeds are limited by the internally-compensated opamps found in SC integrators, a common building block...
Advances in electronic systems have lead to the demand for high resolution, high bandwidth Analog-to-Digital Converters (ADCs). Oversampled ADCs are well- known for high accuracy applications since they benefit from noise shaping and they usually do not need highly accurate components. However, as a consequence of oversampling, they have limited...
Time-domain data conversion has recently drawn increased research attention for its highly digital nature in favor of process technology scaling. Also, as the time information being carried by binary voltage, time-domain operation is much less sensitive to voltage noise compared to conventional voltage domain operation. However, for analog-to-digital converter (ADC)...
Pipelined analog to digital converters (ADCs) are very important building blocks in many electronic systems such as high quality video systems, high performance digital communication systems and high speed data acquisition systems. The rapid development of these applications is driving the design of pipeline ADCs towards higher speed, higher dynamic...
Hand-held devices are among the most successful consumer electronics in modern society. Behind these successful devices, lies a key analog design technique that involves high-performance analog-to-digital conversion combined with very low power consumption. This dissertation presents two different approaches to achieving high power efficiency from a two-step pipelined architecture, which...
The continued scaling of deep-submicron CMOS technology enables low-voltage high-frequency phase-locked loops (PLLs) to be fully integrated in complex mixed-signal systems. However, fluctuations due to the manufacturing process and variations in
environmental conditions, such as supply voltage and temperature, are also significantly increased. As a result, the performance of PLLs...
A duty-cycle controlled switched resistor is a tunable resistive element that uses pulse width modulation as the method of tuning. This thesis will describe the operation of switched resistors and propose several circuit architectures that are well suited to the use of switched resistors. These architectures include filters, mixers, and...
This dissertation presents a phase domain in-loop-bandwidth spread-spectrum clock generation technique. In this proposed technique, a charge-based discrete-time loop filter is proposed to enable the phase domain in-loop-bandwidth spread-spectrum modulation without a delta-sigma modulator or time-to-digital converter. The in-loop-bandwidth modulation technique maximizes the loop bandwidth to improve phase noise suppression...
Digital-to-analog converters (DACs) with wide dynamic range and high
linearity are required for high-end audio applications. A multi-bit delta sigma
audio DAC, using a novel gain-correction technique, is described in this thesis. For
widely varying on-chip RC time constant, the DAC gain can be accurately
controlled by the correction circuitry....
Advances in process technologies have led to the development of low-power high speed digital signal processing blocks that occupy small areas. These advances are critical in the development of portable electronic devices with small feature size and long battery life. However, the design of analog and mixed-signal
building blocks, especially...
Scaling of CMOS technology has progressed relentlessly for the past several
decades. In order for this unprecedented scaling to benefit the performance of
large digital systems, the communication bandwidth between integrated circuits
(ICs) must scale accordingly. However, interconnect technology does not scale as
aggressively, making communication between chips the major...
Demands of today's integrated society dependent on communication systems have driven the creation of ever more efficient analog-to-digital converters. For the same reasons, digital circuitry has rapidly expanded to serve all the different systems and needs of consumers. The trend of technology development has been to make these digital circuits...
Low noise oscillators are universally needed in digital systems for clock generation and synchronization, and in radio-frequency communication front-ends for frequency up- and down-conversion. Noise in oscillators results in timing jitter, and limits the clock frequency of digital systems. In radio-frequency communication systems, phase noise in oscillators lowers the signal-to-noise...
In an industrial and consumer electronic marketplace that is increasingly demanding greater real-world interactivity in portable and distributed devices, analog to digital converter efficiency and performance is being carefully examined. The successive approximation (SAR) analog to digital converter (ADC) architecture has become popular for its high efficiency at mid-speed and...
A digital implementation of a PLL has several advantages compared to its
analog counterpart. These include easy scalability with process shrink, elimination
of the noise susceptible analog control for a voltage controlled oscillator (VCO) and
the inherent noise immunity of digital circuits. Several recent digital PLL (DPLL)
implementations have achieved...
This work presents a high-resolution Delta-Sigma ADC which combines the use of the pseudo-pseudo-differential noise filtering technique with single-ended ring amplifier based integrators. The pseudo-pseudo-differential noise filtering technique utilizes single-ended circuits while maintaining the even-order rejection found in fully-differential structures which alleviates, in the active analog blocks, the need for...
As the functionality of digital chips continues to increase dramatically, chip- to-chip communication bandwidths must scale accordingly to avoid constraining the overall system performance. Therefore, high speed transceiver design has be- come an important research topic. In particular, the performance of the circuits that are responsible for timing accuracy are...
A comprehensive and scalable solution for high-performance switched capacitor amplification is presented. Central to this discussion is the concept of ring amplification. A ring amplifier is a small modular amplifier derived from a ring oscillator that naturally embodies all the essential elements of scalability. It can amplify with accurate rail-to-rail...
Phase-locked loop (PLL) frequency synthesizers lie at the heart of most radio transceivers. An important objective of the electronics and communications industry is to design high-speed building blocks which dissipate the lowest possible power, and to ac- complish this with the cheapest technology. The dual-modulus prescaler is one of the...
Delta-sigma analog-to-digital converters (ADCs) are suitable for many applications due to several advantages such as relaxed anti-aliasing filter, high signal-to noise and distortion ratio (SNDR) and most important of all, reduced sensitivity to
analog imperfections.This thesis introduces several structures to overcome loop imperfections and stability issues in delta-sigma modulators. First,...
Modern day CMOS processes are characterized by voltage scaling and geometry scaling. Geometry scaling helps reduce gate delays, thereby aiding in the design of data converters which use time based processing. Another artifact of geometry scaling is the increase in complexity of digital circuitry available on traditional analog ICs, as...
This thesis describes circuit architectures and techniques that facilitate the
automatic synthesis and fabrication of analog-to-digital converters (ADCs). Since
automated synthesis already exists for digital circuits and is part of the digital
circuit design flow, this work demonstrates the feasibility of ADC synthesis with
little or no modification to presently...
The internet-of-things is a growing market segment which is based on an arrayof portable communication devices with high power efficiency. Advanced semiconductortechnology can easily improve their digital performance, but the samecannot be said for the analog blocks which are vital to their operation. Highperformance analog circuits continue to use conventional...
Circuits operating outside the earth’s atmosphere are more vulnerable to cosmic radiation and require special design consideration. The purpose of this work is to explore methods of mitigating the effect of radiation in phase locked loop (PLL) circuits. Several voltage controlled oscillators (VCOs) and two complete PLLs are designed and...
The most accurate method for performing analog signal processing in MOS (metal-oxide-semiconductor) integrated circuits is through the use of switched-capacitor circuits. A switched-capacitor circuit operates as a discrete-time signal processor. These circuits have been used in a variety of applications, such as filters, gain stages, voltage-controlled oscillators, and modulators. A...