The heat-transfer mechanism studied in this experiment was
pool boiling from a flat horizontal surface facing upward with the
bulk liquid at its saturation temperature. The hot-film anemometer
probe was introduced to boiling heat-transfer analysis as a possible
device for counting active nucleation sites and for other investigations
such as...
A qualitative evaluation was made of the adherence between
borosilicate glass and the ceramics, steatite and alumina. Three
basic adherence studies were performed.
(1) A comparison between the x-ray diffraction patterns of
the ceramic and the fused glass-ceramic powder mixture was made
to determine if any new compounds were formed...
The effects of round, square, and reentrant entrances on flow
regimes and local heat transfer coefficients were determined using a symmetrical,
plane-wall two-dimensional, subsonic air diffuser with one
of the diverging walls heated and maintained isothermal.
Flow and heat transfer studies were made at total divergence
angles ranging from 0...
The purpose of this thesis work has been the design, construction
and calibration of an instrumented surface for convective heat
transfer studies. The surface is in the form of a flat plate roughly
24 inches wide by 48 inches long. It is made up of 48 individual
cells, laminated side-by-side...
The free convective heat transfer phenomena in air between two
vertical plates 24 by 38 inches spaced 15.895 mm apart, was investigated in this experimental study. One plate was isothermal and, the
other adiabatic.
A quartz fiber anomometer was used for measuring local
velocities in the air between the vertical...
There is need for more knowledge of the naturally acquired
diseases of the laboratory rat. Respiratory diseases occurring in
the species were reviewed with special reference to an acute respiratory
disease affecting certain rats in the Oregon State University
closed Wistar rat colony which has also involved human infections.
The...
Radiation induced heat generation rates of several nonfissionable materials were measured calorimetrically in a nuclear reactor environment. The calorimeter was uniquely designed to allow many materials of grossly different heat generation rates to be measured. heat transfer characteristics of the calorimeter were determined analytically and experimentally. Materials were chosen to...
The heat-transfer phenomena studied in this work were
associated with pool boiling from a flat horizontal surface facing
upward with the bulk liquid at its saturation temperature. The
analysis of boiling sound and the investigation of the transition boiling
mechanism constituted the essence of the present study.
The distinctively large...
To study the association between Fusarium root-rot resistance
(Fusarium solani f. sp. phaseoli) and economically inportant characteristics
of beans, 2259 lines each consisting of 30 plants were used.
The lines were randomly selected for root-rot reaction, but were
selected for differences in vigor and differences in plant and seed
pigments,...
Southern pine and Douglas fir veneer samples were dried in air
under the following conditions: air temperatures were 350, 600, and
750°F; air velocities were 50, 100, and 150 feet per second, and
angles of impingement of air against the veneer surfaces were 0°,
45°, and 90°. The resulting drying...
Pea streak virus (Marmor trifolii Holmes) is widespread and
occasionally destructive in Eastern Oregon and Washington, and in
many other pea growing areas. Since control by the use of insecticides
to kill the insect vector is only partially successful, resistant
varieties of peas are needed.
In a study to confirm...