The three dimensional structure of both a ligand and its cognate receptor are required for the success of structure-assisted drug design. This thesis reports the crystal structure of hectochlorin, a small, bioactive molecule, and the steps toward determining the crystal structure of an RNA molecule that is an attractive target...
Nickel or nickel alloys are common materials used in under bump metallization (UBM) in flip chip technology. Nickel is used because of its slow reaction rate with tin-based solder at
elevated temperatures. However, nickel is ferromagnetic at room temperature, hence cannot be easily deposited with magnetron sputtering. In this study,...
We have performed fluorescence extended X-ray absorption fine structure (EXAFS) measurements on the Cd K-edge of partial electrolyte (PE) treated Cu(In[subscript 0.7]Ga[subscript 0.3])Se₂ (CIGS) thin film samples using synchrotron X-ray radiation. This data was compared to the EXAFS spectra of CdSe and CdO standards. Cd local structure models were constructed...
A preparative method for a new compound n-octadecylcycloazadi-boron (CAB), in high yield has been developed. CAB was isolated as
an intermediate in the octadecylamine-catalyzed hydrolysis of pentaborane.
The most probable structure of CAB can be regarded as a
derivative of the three membered ring cycloazadiboron with a
n-octadecyl group substituted...
In order to better predict the aggregation state of nanomaterials, the factors that influence aggregation must be understood. The combined effects of natural and engineered coatings have been shown to factor into nanoparticle aggregation behavior in preliminary research. In this study, aggregation behaviors of gold nanoparticles with two different engineered...
Recent interest in oxy-fuel combustion for carbon capture, as well as advancements in technologies such as magnetics, materials, and computational modeling has sparked renewed interest in magnetohydrodynamic (MHD) power generation. The increased temperatures of oxy-fuel combustion versus air-fuel combustion poses a challenge in the selection of materials for plasma exposed...
Digital printing techniques offer several advantages in manufacturing electronics such as direct writing of materials, reduction of chemical waste, and scalability. In particular, printing can significantly simplify manufacturing processes by directly defining the channel area, the gate, and the source and drain contacts, allowing for lower costs and higher throughput...
The level of reactive oxygen species (ROS) is tightly regulated in biological systems as overproduction can lead to oxidative stress and result in a number of diseases. Due to its negative effects, antioxidants are studied and used against ROS in medicine, pharmaceuticals and therapeutics. Because of issues with the uptake...
The fate and transport of engineered nanoparticles (ENPs) such as titanium dioxide (TiO₂) are of concern due to their increasing use in consumer products. Although analytical methods for detection and quantification of ENPs in environmental matrices are being developed, these methods are difficult, time consuming, and not easily validated for...