The study of the effects of diethyldithiocarbamate (DEDTC) in some diseases is in focus for many years. However, DEDTC is a metal chelator that can present neurotoxicity as side effects. Here we investigate the effect of DEDTC on brain Zinc (Zn) content and behavior. To address this issue we used...
A series of combined measurements was made at the Naval Air Station North Island (NASNI) Installation Restoration Site 5, Unit 2 during July and August 2013. Combined measurements included CO₂ respiration rate, CO₂ radiocarbon content to estimate chlorinated hydrocarbon (CH) mineralization and a zone of influence (ZOI) model. CO₂ was...
Porous substrates transport fluid via capillary action and can be inexpensive, making them ideal for field-use sensors. Direct wax printing is one of the most commonly used fabrication methods to define fluid paths in standard substrates like cellulose and nitrocellulose. However, direct wax printing is not possible for flexible materials...
We demonstrate a novel synthetic route to fabricate a one-dimensional
peapod-like Sb@C structure with disperse Sb
submicron-particles encapsulated in carbon submicron-tubes.
The synthetic route may well serve as a general methodology
for fabricating carbon/metallic fine structures by thermally
reducing their carbon-coated metal oxide composites.
Acenes larger than pentacene are predicted to possess enticing electronic properties, but are insoluble and prone to rapid decomposition. Utilizing a combination of functionalization strategies, we present stable, solution processable hexacenes and an evaluation of their hole and electron transport properties.
This study describes the combined experimental and computational elucidation of the mechanism and
origins of stereoselectivities in the NHC-catalyzed dynamic kinetic resolution (DKR) of α-substituted-β-ketoesters. Density functional theory computations reveal that the NHC-catalyzed DKR proceeds by two
mechanisms, depending on the stereochemistry around the forming bond: 1) a concerted, asynchronous...
A novel method of copper indium diselenide nanoparticle
(CuInSe₂ NP) synthesis using a two-step, continuous flow,
solar microreactor is reported here. This method allows for
exceedingly fast heating and short reaction times using only
radiative heat transfer from simulated, concentrated solar
radiation. Chalcopyrite and sphalerite CuInSe₂ phases have
both been...
Solvent extraction is an integral chemical and biochemical separation process that is drastically intensified in microfluidic systems. A novel high-throughput micro-separator was additively manufactured for the intensification of liquid–liquid separation. The micro-posts array within the flow plate generated a capillary pressure gradient on the non-wetting organic phase, enabling continuous, membrane-free,...
Desferrioxamine B (DFOB) was reversibly and covalently conjugated to polystyrene microspheres via N-succinimidyl 3-(2-pyridyldithio)propionate (SPDP) crosslinker. DFOB retained post-immobilization activity with at least 89% able to bind Fe(III)-citrate under pH 7.4 and a citrate:iron molar ratio = 100:1. Comparing iron capture by DFOB-activated beads and sulfhydryl (−SH) control beads demonstrated...
TAML activators promise a novel water treatment approach
by efficiently catalysing peroxide-based degradation of
chemicals of high concern at environmental concentrations.
Green design ethics demands an exploration of TAML
toxicity. Exposure to high concentrations of certain activators
caused adverse effects in zebrafish. At typical TAML
operational concentrations, development was not...