The advance of digital IC technology has been very fast, as shown by rapid development of DSP, digital communication and digital VLSI. Within electronic signal processing, analog-to-digital conversion is a key function, which converts the analog signal into digital form for further processing. Recently, low-voltage and low-power have become also...
Continuous process scale-down and emerging markets for low-power/low-voltage mobile systems call for low-voltage analog integrated circuits. Switched-capacitor (SC) circuits are the building blocks for analog signal processing and will encounter severe overdrive problems when operating at low voltage conditions. There exist three techniques to solve the problem, but with their...
The design of a switched capacitor successive approximation A/D converter is discussed in this thesis. This design adopts a novel capacitance mismatch error cancellation algorithm proposed in references [25, 27]. Detailed charge domain analysis is given in this thesis, which results in an improvement of the proposed algorithm by tracing...
In this thesis, the literature relating to charge pump dc-dc converters and their uses is reviewed. Charge pumps are useful in many circuits, including low-voltage circuits, dynamic random access memory circuits, switched-capacitor circuits, EEPROM's and transceivers. The important issues relating to charge pump design are power efficiency, output voltage ripple...
The design of mixed-signal integrated circuits has evolved from simple analog and digital circuits operating on the same silicon substrate to the point that now we have complete system on a chip solutions for communication systems. The levels of integration needed to remain cost effective in today's integrated circuit (IC)...
Switched-capacitor (SC) circuits are commonly used for analog signal processing because they can be used to realize precision filters and data converters on an integrated circuit (IC). However, for high speed applications SC circuit operating speeds are limited by the internally-compensated opamps found in SC integrators, a common building block...
Utilizing a two-capacitor topology, the digital implementation of an audio-band successive-approximation analog-to-digital converter (ADC) is explored in the context of mismatch-shaping where the mismatch estimates are accurate to the first order. A second-order Δ∑ loop was found to be effective in system simulations given a 0.1% capacitor mismatch. Spectral analysis...
In this work a new voltage buffer, the drain-follower, achieves 300MHz band-width with 2pF load, a dc gain of 0.993V/V, 1mV offset voltage, -60 dB total harmonic distortion at 1.4Vpp output voltage and 6.5mW power dissipation from 5V supply. A unity-gain buffer switched-capacitor biquad filter has been implemented in 0.5μm...
Voltage converters or charge pumps find their use in many circuits. They are extensively used in hand held devices as cell phones, pagers, PDA's and laptops. Some of the important issues relating to design of voltage regulators for handheld devices are size, efficiency and noise. Another important factor to be...
A radix-based calibration technique was previously proposed with a two-stage algorithmic analog-to-digital converter (ADC). The objective of this work is to verify the capability of radix-based calibration for a true multi-stage ADC. In order to prove the idea, a single bit-per-stage, 20-stage pipelined ADC is designed in a 0.35-μm CMOS...
This thesis presents a continuous time bandpass delta sigma modulator with frequency translation inside the delta sigma loop. The input IF signal is down converted to baseband after amplification by a low Q, wideband bandpass resonator. The down converted IF signal is digitized by a continuous time, second order lowpass...
Recently, switched capacitor DC/DC converters are extensively used in portable electronic devices because they feature many advantages, such as high efficiency, small package, low quiescent current, minimal external components and low cost. In this thesis, two step-down switched capacitor DC/DC converters are designed. One has the fixed output options 1.5V,...
Phase-locked loop (PLL) frequency synthesizers lie at the heart of most radio transceivers. An important objective of the electronics and communications industry is to design high-speed building blocks which dissipate the lowest possible power, and to ac- complish this with the cheapest technology. The dual-modulus prescaler is one of the...
A tuning technique which tunes the continuous time filter very accurately is proposed in this thesis. This technique overcomes the problem of master slave mismatch, thus tuning the filter accurately. The mismatch minimization is done on power up on foreground while the background tuning is always operational. Once the mismatch...
The objective of this work is to explore the feasibility of replacing conventional op-amps with inverters in switched-capacitor (SC) circuits. In order to verify the idea, a low-pass filter (LPF) and a second-order delta-sigma (∆Σ) analog-todigital converter (ADC) are designed in the 0.5-m CMOS technology. The low-pass filter structure is...
A novel switched-R-MOSFET-C input branch is proposed for low-voltage and high-linearity applications. The tunability is achieved by varying the clock duty cycle using an automatic tuning circuit. This tuning method does not involve a change in gate voltage, and is therefore particularly suitable for low-voltage applications. The advantages of the...
This thesis presents a novel algorithmic A/D converter to be used in a biosensor. The converter is capable of a conversion rate of 1.5 bits/phase and hence the required conversion time is reduced. The proposed architecture is analyzed for non-ideal effects and compared with existing algorithmic A/D architectures. The converter...
This thesis proposes a novel technique for the design of pipelined and cyclic ADCs utilizing generalized radix gain stages. Several models have been proposed for the optimization of high performance pipelined ADCs by various researchers. This work builds upon them, using a simple but accurate model to estimate the optimal...
Pipeline analog-to-digital converters (ADCs) have long been used in high-speed systems for power-efficient data conversion. Broadband communication and video processing systems are placing high demands on converter accuracy and speed (above 14 bits and in the multiple-MHz range). The increasing converter requirements coupled with lower supply voltages in modern processes...
The world market for sensors is several hundred million dollars growing at an annual rate of 20 percent with accelerometers comprising 19 percent of the market. With an increasing market, a wide range of applications with varying degrees of resolution are in demand. Therefore, there is sufficient motivation for developing...
Spacecrafts experience radiation in the course of their operation
and all electronic equipment on board these spacecrafts has to
be designed to withstand the effects of this radiation.
This thesis describes the effects of total ionization dose (TID)
and single event transients (SET) in phase-locked loops - an
important circuit...
Circuits operating outside the earth’s atmosphere are more vulnerable to cosmic radiation and require special design consideration. The purpose of this work is to explore methods of mitigating the effect of radiation in phase locked loop (PLL) circuits. Several voltage controlled oscillators (VCOs) and two complete PLLs are designed and...
Digital phase-locked loops (PLLs) have been receiving increasing attention recently due to their ease of integration, scalability and performance comparable to their analog counterparts. In digital PLLs, increased resolution in time-to-digital conversion is desirable for improved noise performance. This work describes the design and simulation of a stochastic time-to-digital converter...
There is a large and growing market for portable consumer audio products
with very small size. As the size of these products is reduced, the area occupied
by batteries becomes significant and hence limits the number of batteries to one.
In order to build such small products, high levels of...
This thesis presents a comparison of time-domain and frequency-domain algorithms for phase noise calculation in oscillators. Floquet theory provides the mathematical foundation for these calculations and the numerical methods employ perturbation projection vectors (PPVs). The PPVs are an estimate of an oscillator's sensitivity to noise.
The in-house circuit simulator SPICE3...
A digital phase locked loop (DPLL) and a statistical time-to-digital converter (STDC) were previously fabricated in a 0.35µm, 3.3V SOI CMOS process. This work summarizes these designs and characterizes the measured performance. Simulations supplement the measurements where applicable.
The DPLL was found to reach a locked state under a limited...
To realize pipelined ADCs in deep-submicron processes, low voltage techniques
must be developed to work around problems created by limited supply voltages such as
the floating switch dead zone, reduced SNR, and reduced OpAmp performance.
This thesis analyzes standard and low voltage design issues for pipelined ADCs
and proposes a...
Recent publications show that successive approximation register (SAR) analog to digital converters (ADC) are capable of achieving high efficiency over other ADC topologies. Furthermore, techniques have been adopted to process signals with low activity periods, such as biomedical and industrial sensors. Prior work used least- significant bit first quantization (LSBFQ)...
New amplifier architectures are presented using non-traditional methods of biasing. Time-based dynamic biasing and signal-based dynamic biasing are discussed in the context of new architectures. This includes a new form of ring amplification with a dynamic deadzone, allowing for a structure whose coarse path does not consume static power.
Analog to digital converters (ADCs) are a critical part of communication between the physical world and the increasingly digital systems humans use every day. ADCs have inherent non-idealities that degrade performance. Nonlinearity is one of the most prevalent non-idealities that designers face. While calibration methods for nonlinearity exist in the...
Ring amplification has emerged as an efficient technique to drive large capacitive loads in switched capacitor circuits. We propose circuit techniques to demonstrate the first application of a ring amplifier in a non-capacitive feedback system of a LDO. These techniques enable a simple cap-less LDO structure in 180nm CMOS that...