Ring amplifiers (ringamps) have shown excellent power efficiency in the latest state-of-the-art analog to digital converters (ADCs). This thesis describes circuit techniques to ensure robust operation of ringamps using standard analog techniques and proportional-integral-derivative(PID) controller analogy. Large-signal and small-signal analysis of a ringamp are performed using simple RC settling and...
This thesis deals with target localization using multiple-input multiple-output (MIMO) radars. In the field of communications, navigation, radar, and sensing networks, one of the common and most sophisticated problems is target localization. We develop a target localization scheme in distributed MIMO radar systems using bistatic range measurements. The localization approach...
Conventional Delta-Sigma analog-to-digital converters (ADCs) utilize operational transconductance amplifiers (OTAs) in their loop filter implementation followed by multi-bit voltage domain quantizers. As CMOS integrated circuit technology scales to smaller geometries, the minimum transistor length and the intrinsic gain of the transistors decrease. Moreover, with process scaling the voltage headroom decreases...
In recent years, SAR ADCs have been shown to acheive faster conversion times and improved power efficiencies due to their simple building blocks that are digital in nature and scale favorably with technology. High resolution ADCs with stringent noise requirement has led to the adoption of hybrid ADC architectures such...
Portable, high power efficiency communication devices is a growing market in the semiconductor industry. Analog-to-digital converters (ADC) are key interface that are used to digitize the sensed information. Recently, digital techniques have been proposed to improve analog building block power efficiency in sub-micron technologies. This research focuses on mixed signal...
Noise-shaping multibit quantizers in a ΔΣ modulator offer extra orders of noise shaping without increasing the loop-filter order and without compromising the stability of the modulator. This dissertation presents two new architectures for improving the overall performance of continuous-time ΔΣ modulators using noise-shaped quantizers.
The first modulator architecture is motivated...
For mmWave Integrated Circuit (IC) design, co-integration of passives can reduce size and power consumption, increase reliability, and reduce overall cost. However, skin and proximity effects in the metallization are aggravated at mmWave frequencies, resulting in increased attenuation and degradation of overall performance. Furthermore, tight integration of passive components (to...
Demands of today's integrated society dependent on communication systems have driven the creation of ever more efficient analog-to-digital converters. For the same reasons, digital circuitry has rapidly expanded to serve all the different systems and needs of consumers. The trend of technology development has been to make these digital circuits...
The internet-of-things is a growing market segment which is based on an arrayof portable communication devices with high power efficiency. Advanced semiconductortechnology can easily improve their digital performance, but the samecannot be said for the analog blocks which are vital to their operation. Highperformance analog circuits continue to use conventional...
Wireless power transfer (WPT) is a way to transfer power from one device to another without any wire or cable connections. Although the technology has been around for more than 100 years, it is gaining popularity in recent years due to the ever-increasing demand for faster and more frequent charging...
As the CMOS process scales down to submicron, digital circuit performance improves, while reduced supply voltage and lower transistor intrinsic gain make it difficult to implement analog circuits in a power efficient manner. Therefore, it has become advantageous to shift more analog signal processing functions conventionally realized in voltage (analog)...
This dissertation presents a phase domain in-loop-bandwidth spread-spectrum clock generation technique. In this proposed technique, a charge-based discrete-time loop filter is proposed to enable the phase domain in-loop-bandwidth spread-spectrum modulation without a delta-sigma modulator or time-to-digital converter. The in-loop-bandwidth modulation technique maximizes the loop bandwidth to improve phase noise suppression...
A procedure for automating the design and layout of analog-to-digital converters (ADCs) is presented. This procedure makes use of the existing synthesis and place-and-route tools that are common in digital circuit design. A method for adding rudimentary analog cells to the standard library is described, allowing the designer to synthesize...
Recent publications show that successive approximation register (SAR) analog to digital converters (ADC) are capable of achieving high efficiency over other ADC topologies. Furthermore, techniques have been adopted to process signals with low activity periods, such as biomedical and industrial sensors. Prior work used least- significant bit first quantization (LSBFQ)...
Time-domain data conversion has recently drawn increased research attention for its highly digital nature in favor of process technology scaling. Also, as the time information being carried by binary voltage, time-domain operation is much less sensitive to voltage noise compared to conventional voltage domain operation. However, for analog-to-digital converter (ADC)...
The addition of thin-film alloy magnetic materials to integrated circuit processing enables a number of novel monolithic circuits. Examples include fully integrated magnetic field sensors, signal and power galvanic isolation circuits, and power supplies on chip (PwrSoC). There are several benefits to integrating these traditionally off-chip devices, including improved manufacturability,...
Energy consumption is one of the primary bottlenecks to both large and small scale modern compute platforms. Reducing the operating voltage of digital circuits to voltages where the supply voltage is near or below the threshold of the transistors has recently gained attention as a method to reduce the energy...
VCO-based ADCs have recently emerged as attractive alternative to conventional DeltaSigma (ΔΣ) modulator architectures. Few salient features of a VCObased ADC are: 1) the quantization noise is 1st order noise shaped, 2) it is an open loop architecture, and, 3) its implementation is mostly digital in nature. Hence, they are...
In this dissertation, time-based signal processing techniques and their applications in oversampling and noise-shaping data converters are examined. These techniques demonstrate the ability to shift the burden of high performance analog circuits from the compressed voltage-domain to the augmented time-domain. First, the potential of high order noise-shaping and phase-domain feedback...
Ultra-high-speed (>10GS/s), medium-resolution (5~6bit), low-power (<50mW) analog-to-digital converter can find it application in the areas of digital oscilloscopes and next-generation serial link receivers. There are several challenges to enable a successful design, however. First, the time-interleaved architecture is required in order to achieve over 10GS/s sampling rate, with the trade-off...
In an industrial and consumer electronic marketplace that is increasingly demanding greater real-world interactivity in portable and distributed devices, analog to digital converter efficiency and performance is being carefully examined. The successive approximation (SAR) analog to digital converter (ADC) architecture has become popular for its high efficiency at mid-speed and...
Desire for low-power, high performance computing has been at core of the symbiotic union between digital circuits and CMOS scaling. While digital circuit performance improves with device scaling, analog circuits have not gained these benefits. As a result, it has become necessary to leverage increased digital circuit performance to mitigate...
A comprehensive and scalable solution for high-performance switched capacitor amplification is presented. Central to this discussion is the concept of ring amplification. A ring amplifier is a small modular amplifier derived from a ring oscillator that naturally embodies all the essential elements of scalability. It can amplify with accurate rail-to-rail...
Complex digital circuits such as microprocessors typically require support circuitry that has traditionally been realized using analog or mixed-signal macros. PLL circuits are used in many integrated applications such as frequency synthesizers and inter-chip communication interfaces. As process technologies advance and grow in complexity, the challenge of maintaining required analog...
Low power, high speed serial transceivers are employed in a wide range of applications ranging from chip-to-chip, backplane, and optical interconnects. Apart
from being capable of handling a wide range of data rates, the transceivers should
have low power consumption (mW/Gbps) and be fully integrated. This work
discusses enabling techniques...
As Moore’s Law continues to give rise to ever shrinking channel lengths, circuits are becoming more digital and ever increasingly faster. Generating high frequency clocks in such scaled processes is becoming a tough challenge. Digital phase locked loops (DPLLs) are being explored as an alternative to conventional analog PLLs but...
There is a significant need in recent mobile communication and wireless broadband
systems for high-performance analog-to-digital converters (ADCs) that have wide
bandwidth (BW>5-MHz) and high data rate (>100-Mbps). A delta-sigma ADC is
recognized as a power-efficient ADC architecture when high resolution (>12-b) is
required. This is due to several advantages...
Dual referencing has been garnering a lot of attention in the power integrity community, specifically in the voltage mode driver application because it shows a lower overall power delivery noise (PDN) compared to other signal referencing types. Additionally, the increasing push to drive down package and board manufacturing costs is...
Supply noise is one of the major considerations in almost all analog building blocks. In the past, adequate supply rejection is usually achieved with circuit isolation or excess capacitive coupling. However, this brute force method requires large silicon area and degrades feedback bandwidth. In this study, a method of enhancing...
Phase-Locked Loops (PLLs) are essential building blocks in many communication systems. Designing high performance analog PLLs in the presence of technology imposed constraints such as leakage, poor analog transistor behavior, process variability, and low supply voltage is a challenging task. To overcome these drawbacks, digital PLLs (DPLLs) have recently emerged...
Delta-sigma analog-to-digital converters (ADCs) are suitable for many applications due to several advantages such as relaxed anti-aliasing filter, high signal-to noise and distortion ratio (SNDR) and most important of all, reduced sensitivity to
analog imperfections.This thesis introduces several structures to overcome loop imperfections and stability issues in delta-sigma modulators. First,...
Various applications like wireless UWB communication, fast data acquisition systems and digital storage oscilloscopes needs ADCs with instantaneous input signal bandwidth from 0.1-40 GigaHertz range with 6-10 bits of resolution -- a challenging task and an impressive goal to achieve. Flash ADCs have been conventionally employed to achieve these goals...