Search Constraints

Start Over
Filtering by: Creator Busche, Jacob A. Remove constraint Creator: Busche, Jacob A. Degree Field Electrical and Computer Engineering Remove constraint Degree Field: Electrical and Computer Engineering

Search Results

  • Energy efficient communication across on-chip wires in digital CMOS

    Creator:
    Postman, Jacob
    Abstract:
    For the past half century, CMOS process scaling has followed Moore's law, approximately doubling transistor density every 18 months. While locally routed wires have generally scaled with transistor size, longer wires have scaled at a slower rate and in some cases have grown larger as chip size and complexity have...
    Resource Type:
    Dissertation
    Full Text:
    Digital CMOS by Jacob Postman A DISSERTATION submitted to Oregon State University in partial

  • Ultra low capacitance RFIC probe

    Creator:
    Jacob, Michael E.
    Abstract:
    In Radio Frequency Integrated Circuits (RFIC) or high frequency digital ICs, there is a demand to probe the internal nodes for testing. The ultra low capacitance RFIC probe presented in his work is a flexible tool for these applications. The probe utilizes the coupling between a tungsten needle and the...
    Resource Type:
    Masters Thesis
    Full Text:
    Michael E. Jacob A THESIS submitted to Oregon State University in partial

  • Design, Layout, and Testing of a Printed Circuit Board for Cyclic Voltammetry

    Creator:
    Harper, Karen
    Abstract:
    This project concerns the design, layout, assembly, debugging, and testing of a Printed Circuit Board (PCB) that autonomously, reliably, and effectively conducts Cyclic Voltammetry (CV) measurements. CV is an electrochemical procedure done to analyze, quantize, and visualize reversible reduction-oxidation reactions, often used in medical devices to monitor the levels of...
    Resource Type:
    Honors College Thesis
    Full Text:
    thesis pro- cess Thank you to Jacob Dawes, a Ph.D. student in Dr. Johnstons lab, for providing the

  • Implementing a Low Power Soil Monitoring System for Small- and Large-Scale Applications

    Creator:
    Marshall, Jordyn
    Abstract:
    Due to increasing populations, food production must increase significantly to be sustainable. The Internet of Things has been shown to have potential in the field of agriculture to make farming practices more efficient. However, for IoT to be properly integrated into agriculture, sensors must be applied within the field and...
    Resource Type:
    Honors College Thesis
    Full Text:
    Implementing a Low Power Soil Monitoring System for Small

  • SIMstat: Hardware Design Considerations for Implementing a Low-Cost, Portable Potentiostat

    Creator:
    Cook, Jacob M.
    Abstract:
    Electroanalytical techniques allow scientists and engineers to characterize bulk solutions as well as interfaces. Potentiostats are commonly used by researchers in a variety of disciplines to analyze the chemistry which occurs at a working electrode surface. Advancements in microelectronics and the proliferation of open-source designs have allowed researchers to construct...
    Resource Type:
    Honors College Thesis
    Full Text:
    SIMstat: Hardware Design Considerations for Implementing a Low-Cost, Portable Potentiostat by Jacob

  • Investigation of a noise-shaping accelerometer interface circuit for two-chip implementation

    Creator:
    Zechmann, Jacob W.
    Abstract:
    The world market for sensors is several hundred million dollars growing at an annual rate of 20 percent with accelerometers comprising 19 percent of the market. With an increasing market, a wide range of applications with varying degrees of resolution are in demand. Therefore, there is sufficient motivation for developing...
    Resource Type:
    Masters Thesis
    Full Text:
    by Jacob W. Zechmann June 30, 2005 All Rights Reserved _j Investigation of a Noise-Shaping

  • Prototyping of Thermoelectric Energy Harvesting Circuitry for IoT Devices

    Creator:
    Webb, Derek
    Abstract:
    Due to the advancement of incredibly low power microcontrollers and small form factor integrated circuits, energy harvesting can be considered as an alternative, low power source for remote ocean sensing and measurements. To demonstrate the effectiveness of harvesting thermoelectric energy contained in the temperature differential between ocean surface water and...
    Resource Type:
    Honors College Thesis
    Full Text:
    IoT Devices By Derek Webb A THESIS submitted to Oregon State University Honors College in

  • Design and Modeling Techniques for Impedance Based Flow Cytometry

    Creator:
    Dawes, Jacob
    Abstract:
    Microfluidic devices have enabled lab-on-a-chip (LOC) systems that allow for complex sample analysis and preparation in a compact form factor. One technology that may benefit from a microfluidic approach and further miniaturization is flow cytometry. Flow cytometry is an analysis technique for enumerating and characterizing populations of cells; this is...
    Resource Type:
    Masters Thesis
    Full Text:
    for Impedance-Based Flow Cytometry by Jacob Dawes A THESIS submitted to Oregon State University

  • Plasma-Jet Printing and In Situ Sintering of Electronic Materials for Flexible Hybrid Electronic Applications

    Creator:
    Manzi, Jacob
    Abstract:
    Additive manufacturing has become a promising method for the fabrication of inexpensive, green, flexible sensors and electronics. Printed electronics on low- temperature substrates are very appealing for the flexible hybrid electronics market for their use in disposable and biocompatible electronic applications and in areas like packaging, wearables, and consumer electronics....
    Resource Type:
    Dissertation
    Full Text:
    AN ABSTRACT OF THE DISSERTATION OF Jacob

  • SIMstat: Wireless, Highly-Reconfigurable Electrochemical Analog Front-End for Point-of-Care Diagnostics and Continuous Monitoring

    Creator:
    Cook, Jacob M.
    Abstract:
    Within the past decade, the continued-scaling of CMOS processes and improvements in industry mixed-signal integrated-circuit designs have enabled a rapid decrease in the cost, form-factor, and power for point-of-care diagnostics and electrochemical instrumentation. Similarly, advances in low-power RF designs have prompted entire System-on-Modules supporting widely varied Internet-of-Things (IoT) applications. The...
    Resource Type:
    Masters Thesis
    Full Text:
    Front-End for Point-of-Care Diagnostics and Continuous Monitoring by Jacob Matthew Cook A MASTERS